On Wed, Jul 03, 2002 at 08:01:28AM +0200, Hugo van der Merwe wrote: [...] > (Since I used /boot/config-2.4.16, and compiled another 2.4.16 kernel, > I'm quite sure the kernel should still be ok? I compiled and installed > new kernel, as I don't know if I can build modules otherwise. What is > always meant by "configured kernel source tree" if you want to compile > modules? Need I always keep a kernel source tree as it was when I > compiled a specific kernel when I want to compile modules for it? A > nuisance as I often compile all my kernels on my fastest machine. Thus I > need to completely recompile the kernel each time I want to compile new > modules?)
AFAIK when you build your kernel using make-kpkg, you can also generate packages with kernel_headers to install later on your slower machine. [...] > Right, so I decided to take out PCMCIA support from the kernel and go > with pcmcia-modules-3.1.33 instead, as that's what pcmcia-cs I have. > Since I don't have menuconfig, I just editted the /usr/src/.config file, > set CONFIG_PCMCIA=n, and left the rest of the PCMCIA options as-is. Is > this adequate? Compiled new kernel, compiled pcmcia-modules, the install > works fine, no conflicts. Mmmh editing .config by hand is quite close to black magic, if I were you, I'd use make config if you can't use menuconfig or xconfig. > After a reboot: > > > Starting PCMCIA services: modulesLinux PCMCIA Card Services 3.1.33 > kernel build: 2.4.16 unknown > options: [pci] [cardbus] [apm] > Intel ISA/PCI/CardBus PCIC probe: > PCI: Enabling device 00:0a.0 (0000 -> 0002) > > Bridge register mapping failed: check cb_mem_base setting > no bridges found. > /lib/modules/2.4.16/pcmcia/i82365.o: init_module: No such device > Hint: insmod errors can be caused by incorrect module parameters, > including invalid IO or IRQ parameters > ds: no socket drivers loaded! > /lib/modules/2.4.16/pcmcia/ds.o: init_module: Operation not permitted > Hint: insmod errors can be caused by incorrect module parameters, > including invalid IO or IRQ parameters > cardmgr. Could you try using the yenta module instead of the i82365 (as defined in /etc/default/pcmcia IIRC) ? For me it did the trick. HTH Fred -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
