Monday, October 08, 2001, 3:10:50 AM, Glen wrote: GM> try 'apt-get install pcmcia-cs' It claims to have the latest version of pcmcia-cs
GM> you'll need to know the chipset of your card, as well as whether or not your card is pcmcia or cardbus-- check the hardware-HOWTO at http://www.linuxdoc.org/ By chipset, do you then mean something like xirc2ps? Ok it looks like I have what I need, but how do I set it up, and get it running? >> >> I'm trying to install on a Dell Inspiron 7500, and I have gotten some hints from >some >> >> of you earlier. But I can't figure out where I setup the PCMCIA card >> >> during the setup (Xircom 10/100/56). The only thing I am asked about my PCMCIA >card, is >> >> whether it's a intel thing or some T... thing. Where do I specify that >> >> it's a xirc2ps? I can't setup my network if I specify intel or T.... >> >> JC> During the PCMCIA installation, you are asked to enter any >> JC> card-specific options as well as a controller type, e.g. i82365. >> JC> After these options are entered and the card services are >> JC> installed, you can then configure the Network. If the install >> JC> process doesn't prompt you directly, you can choose it from the >> JC> list of alternative options below the recommended options in the >> JC> installation script. You don't specify the module to load, it is >> JC> automatically detected by the card services. If it doesn't >> JC> detect the correct card module, you can go into a console from >> JC> the installation script and make some changes to the pcmcia >> JC> config options to help the auto-detect process. >> Well... I finally got my Debian installed with X running (thanks to >> you). I still have no network running, but I don't want to reinstall >> if I can avoid it. How do I get this up and running? I can't apt-get >> from the net (off course), so I have to get whatever I need from my >> CD. What do I do? Can I run some sort of installer, that can help me? -- Med venlig hilsen/Best regards, Søren Neigaard mailto:[EMAIL PROTECTED] -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
