Sorry...I already deleted the original message, so I'll just respond to this one...
I'm using a Toshiba Satellite 2775XDVD, and I'm thoroughly impressed. I
bought a Netgear FA510c eth card, compiled the cardbus and tulip modules that came
with my kernel (test7; didn't try the one off the disk, but at least it was there...),
and it worked off the bat. Unfortunately, it came with a Lucent Winmodem, but the
modem worked perfectly with the ltmodem driver. It uses a Maestro 2E, which was
originally supported in kernel 2.2.14.
The only problems that I have encountered so far are:
(1) The Savage IX/MV that it comes with requires the special X Server available from
S3 and somewhere else (forget where), which can and does cause hardware lockups (it's
still beta...problems should be ironed out soon)
(2) Suspend-to-ram works perfectly, but it doesn't wake up when it's supposed to, and
when I wake it up, there is no picture (might be a suspend vs. XF prob though...)
I attempted to set up my DVD drive, but I was doing that when I was still
using the VGA16 driver. Now, I have the correct X Server, but I had misconfigured
LiViD, and can't find the place to re-configure it...so I'm not sure if it works...
In addition, it has an S/PDIF out, a hardware volume control, and it has 3
spindles (may be good or bad, depending on what you want to do with it...
--xsdg
--
____________________________________________________________________________
/ It is better to let one suspect that you are a fool than to open your mouth\
{ and leave them no doubt. http://xsdg.hypermart.net [EMAIL PROTECTED] }
\____________________________________________________________________________/
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
