I believe that net configurations are OK. Look at:
--My networks.opts file:
# Network adapter configuration
#
# The address format is "scheme,socket,instance,hwaddr".
#
# Note: the "network address" here is NOT the same as the IP address.
# See the Networking HOWTO. In short, the network address is the IP
# address masked by the netmask.
#
case "$ADDRESS" in
*,*,*,*)
# Transceiver selection, for some cards -- see 'man ifport'
IF_PORT="auto"
# Use BOOTP? [y/n]
BOOTP="n"
# Use DHCP? [y/n]
DHCP="n"
# Host's IP address, netmask, network address, broadcast address
IPADDR="192.0.0.2"
NETMASK="255.255.255.0"
NETWORK="192.0.0.0"
BROADCAST="192.0.0.255"
# Gateway address for static routing
GATEWAY="192.0.0.1"
# Things to add to /etc/resolv.conf for this interface
DOMAIN="casa"
SEARCH=""
DNS_1="192.0.0.1"
DNS_2=""
DNS_3=""
# NFS mounts, should be listed in /etc/fstab
MOUNTS=""
# For IPX interfaces, the frame type and network number
IPX_FRAME=""
IPX_NETNUM=""
# Extra stuff to do after setting up the interface
start_fn () { return; }
# Extra stuff to do before shutting down the interface
stop_fn () { return; }
;;
esac
--ifconfig out:
eth0 Link encap:Ethernet HWaddr 00:50:BA:73:0D:13
inet addr:192.0.0.2 Bcast:192.0.0.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
Interrupt:3 Base address:0x300
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:3924 Metric:1
RX packets:18 errors:0 dropped:0 overruns:0 frame:0
TX packets:18 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
Where could be the problem?
Which tests could I do to detect the problem?
Thanks again!!
Carlos Menezes.
Marcus Hagn wrote:
> Are you sure you set your IP in network.opts. What do you see if you type
> 'ifconfig'.
> You have to configure your /etc/pcmcia/network.opts file. just open it
> in an editor and fill out the necessary fields ( IP, NETWORK, BROADCAST,
> GATEWAY? ).
>
> hang loose
> marcus
>
> On Thu, Aug 31, 2000 at 01:13:00AM -0300, Carlos Menezes wrote:
> > I tried to install a PCMCIA card (D-Link DFE-650), which is considered
> > Linux supported.
> > It seems pcmcia support recognized it and included a module called
> > pcnet_cs (I tried with Slackware 7 and Red Hat 6.2). But I CAN'T CONNECT
> > my laptop in my desktop. I read PCMCIA-HOWTO.
> > This adapter has 3 leds; when I'm working in Windows the 3 leds are on;
> > when I boot at Linux these one are blinking (it seems a kind of error
> > message?!?!?!).
> > Please, help me!
> >
> > Thanks in advance!
> > Carlos Menezes.
> >
> > PS.: I copied a piece of /var/log/messages:
> > At boot time:
> >
> > Aug 31 00:19:05 jr kernel: kernel build: 2.2.14-5.0 #1 Tue Mar 7
> > 21:07:39 EST 2000
> > Aug 31 00:19:05 jr kernel: options: [pci] [cardbus] [apm]
> > Aug 31 00:19:05 jr kernel: Intel PCIC probe:
> > Aug 31 00:19:05 jr kernel: TI 1225 PCI-to-CardBus at bus 0 slot 17,
> > mem 0x7fffe000, 2 sockets
> > Aug 31 00:19:05 jr kernel: host opts [0]: [ring] [pwr save] [pci +
> > serial irq] [no pci irq] [lat 66/176] [bus 1/1]
> > Aug 31 00:19:05 jr kernel: host opts [1]: [ring] [pwr save] [pci +
> > serial irq] [no pci irq] [lat 66/176] [bus 2/2]
> > Aug 31 00:19:05 jr kernel: ISA irqs (scanned) = 3,4,7,9,10,15 status
> > change on irq 15
> > Aug 31 00:19:05 jr kernel: cs: IO port probe 0x1000-0x17ff: excluding
> > 0x1000-0x102f
> > Aug 31 00:19:06 jr kernel: cs: IO port probe 0x0100-0x04ff: excluding
> > 0x250-0x257 0x260-0x267 0x378-0x37f 0x4d0-0x4d7
> > Aug 31 00:19:06 jr kernel: cs: IO port probe 0x0a00-0x0aff: clean.
> > Aug 31 00:19:06 jr kernel: cs: memory probe 0xa0000000-0xa0ffffff:
> > clean.
> > Aug 31 00:19:06 jr kernel: eth0: NE2000 Compatible: io 0x300, irq 3,
> > hw_addr 00:50:BA:73:0D:13
> > Aug 31 00:19:06 jr identd: identd startup succeeded
> > Aug 31 00:19:06 jr atd: atd startup succeeded
> > Aug 31 00:19:06 jr crond: crond startup succeeded
> > Aug 31 00:19:07 jr lpd[620]: restarted
> > Aug 31 00:19:07 jr lpd: lpd startup succeeded
> > Aug 31 00:19:07 jr keytable: Loading keymap:
> > Aug 31 00:19:07 jr keytable: Loading
> > /usr/lib/kbd/keymaps/i386/qwerty/us.kmap.gz
> > Aug 31 00:19:07 jr keytable: Loading system font:
> > Aug 31 00:19:07 jr rc: Starting keytable succeeded
> > Aug 31 00:19:08 jr sendmail: sendmail startup succeeded
> > Aug 31 00:19:08 jr gpm: gpm startup succeeded
> > Aug 31 00:19:09 jr xfs: xfs startup succeeded
> > Aug 31 00:19:09 jr xfs: Warning: The directory
> > "/usr/share/fonts/default/TrueType" does not exist.
> > Aug 31 00:19:09 jr xfs: Entry deleted from font path.
> > Aug 31 00:19:09 jr linuxconf: Linuxconf final setup
> > Aug 31 00:19:11 jr rc: Starting linuxconf succeeded
> > Aug 31 00:20:15 jr PAM_pwdb[753]: (login) session opened for user root
> > by LOGIN(uid=0)
> >
> >
> > When I eject and insert the card:
> >
> > Aug 31 00:33:54 jr kernel: eth0: interrupt from stopped card
> > Aug 31 00:33:54 jr cardmgr[212]: shutting down socket 1
> > Aug 31 00:33:54 jr cardmgr[212]: executing: './network stop eth0'
> > Aug 31 00:33:55 jr cardmgr[212]: executing: 'rmmod pcnet_cs'
> > Aug 31 00:33:55 jr cardmgr[212]: executing: 'rmmod 8390'
> > Aug 31 00:34:10 jr cardmgr[212]: initializing socket 0
> > Aug 31 00:34:10 jr cardmgr[212]: socket 0: KTI ETHER-C16 Fast ethernet
> > Aug 31 00:34:10 jr cardmgr[212]: executing: 'insmod
> > /lib/modules/2.2.14-5.0/net/8390.o'
> > Aug 31 00:34:10 jr cardmgr[212]: executing: 'insmod
> > /lib/modules/2.2.14-5.0/pcmcia/pcnet_cs.o'
> > Aug 31 00:34:10 jr kernel: eth0: NE2000 Compatible: io 0x300, irq 3,
> > hw_addr 00:50:BA:73:0D:13
> > Aug 31 00:34:10 jr cardmgr[212]: executing: './network start eth0'
> > Aug 31 00:34:11 jr kernel: eth0: found link beat
> > Aug 31 00:34:19 jr kernel: eth0: lost link beat
> >
> >
> >
> > --
> > To UNSUBSCRIBE, email to [EMAIL PROTECTED]
> > with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
> >
>
> --
> public key: http://leute.server.de/hagan/gpg.txt
> fingerprint: 07D9 F89B 7762 1515 F85E 49BE 86FB 9197 01B5 401A
>
> ------------------------------------------------------------------------
> Part 1.2Type: application/pgp-signature
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
