Package: src:linux
Version: 3.10~rc5-1~exp1
Severity: important
linux 3.10-rc5 fails to boot on this machine.
This machine boots 3.2.0-1-powerpc (from wheezy) just fine. when i
try to boot 3.10-rc5, grub successfully loads the kernel and the
initramfs, and appears to hand off control to the kernel, but then the
machine hangs for several minutes, and ultimately reboots back to
openfirmware.
during the hang, the screen displays a little of the openfirmware info
in reverse video (black on white):
.....
Device tree strings 0x03525000 -> 0x03525bca
Device tree struct 0x03526000 -> 0x03540000
Calling quiesce...
returning from prom_init
and then overwritten over the top of that in normal video (white on
black) is the following messages (i think from the kernel):
setup_arch: bootmem
arch: exit
these same messages come up with kernel 3.2.0-1-powerpc, but that
kernel also says something about hugetlb (before the above two
messages, i think it's in the dmesg output below), but then continues
to boot.
I haven't yet tried kernel 3.9.
--dkg
-- Package-specific info:
** Kernel log: boot messages should be attached
** Model information
revision : 131.0 (pvr 0008 8300)
platform : PowerMac
model : PowerBook2,1
machine : PowerBook2,1
motherboard : PowerBook2,1 MacRISC Power Macintosh
** PCI devices:
0000:00:0b.0 Host bridge [0600]: Apple Inc. UniNorth AGP [106b:0020]
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort+ >SERR- <PERR- INTx-
Latency: 16, Cache Line Size: 32 bytes
Capabilities: <access denied>
Kernel driver in use: agpgart-uninorth
0000:00:10.0 VGA compatible controller [0300]: Advanced Micro Devices, Inc.
[AMD/ATI] Device [1002:4c4e] (rev 64) (prog-if 00 [VGA controller])
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping+ SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 255 (2000ns min), Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 48
Region 0: Memory at 91000000 (32-bit, non-prefetchable) [size=16M]
Region 1: I/O ports at 0400 [size=256]
Region 2: Memory at 90000000 (32-bit, non-prefetchable) [size=4K]
Expansion ROM at 90020000 [disabled] [size=128K]
Capabilities: <access denied>
Kernel driver in use: atyfb
0001:10:0b.0 Host bridge [0600]: Apple Inc. UniNorth PCI [106b:001f]
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx-
Status: Cap- 66MHz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort+ >SERR- <PERR- INTx-
Latency: 16, Cache Line Size: 32 bytes
0001:10:17.0 Unassigned class [ff00]: Apple Inc. KeyLargo Mac I/O [106b:0022]
(rev 02)
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx-
Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 16, Cache Line Size: 32 bytes
Region 0: Memory at 80000000 (32-bit, non-prefetchable) [size=512K]
Kernel driver in use: macio
0001:10:18.0 USB controller [0c03]: Apple Inc. KeyLargo USB [106b:0019]
(prog-if 10 [OHCI])
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx-
Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 16 (750ns min, 21500ns max)
Interrupt: pin A routed to IRQ 27
Region 0: Memory at 80080000 (32-bit, non-prefetchable) [size=4K]
Kernel driver in use: ohci_hcd
0001:10:19.0 USB controller [0c03]: Apple Inc. KeyLargo USB [106b:0019]
(prog-if 10 [OHCI])
Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx-
Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR- INTx-
Interrupt: pin A routed to IRQ 28
Region 0: Memory at <unassigned> (32-bit, non-prefetchable) [disabled]
[size=4K]
0002:20:0b.0 Host bridge [0600]: Apple Inc. UniNorth Internal PCI [106b:001e]
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx-
Status: Cap- 66MHz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort+ >SERR- <PERR- INTx-
Latency: 16, Cache Line Size: 32 bytes
0002:20:0f.0 Ethernet controller [0200]: Apple Inc. UniNorth GMAC (Sun GEM)
[106b:0021]
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx-
Status: Cap- 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=slow >TAbort- <TAbort-
<MAbort- >SERR- <PERR+ INTx-
Latency: 16 (16000ns min, 16000ns max), Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 41
Region 0: Memory at f5200000 (32-bit, non-prefetchable) [size=2M]
Expansion ROM at f5000000 [disabled] [size=1M]
Kernel driver in use: gem
** USB devices:
Bus 001 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
-- System Information:
Debian Release: jessie/sid
APT prefers unstable
APT policy: (500, 'unstable'), (1, 'experimental')
Architecture: powerpc (ppc)
Kernel: Linux 3.2.0-1-powerpc
Locale: LANG=en_US.UTF-8, LC_CTYPE=en_US.UTF-8 (charmap=UTF-8)
Shell: /bin/sh linked to /bin/dash
Versions of packages linux-image-3.10-rc5-powerpc depends on:
ii debconf [debconf-2.0] 1.5.50
ii initramfs-tools [linux-initramfs-tool] 0.113
ii kmod 9-3
ii linux-base 3.5
ii module-init-tools 9-3
Versions of packages linux-image-3.10-rc5-powerpc recommends:
ii firmware-linux-free 3.2
Versions of packages linux-image-3.10-rc5-powerpc suggests:
pn debian-kernel-handbook <none>
pn linux-doc-3.10 <none>
pn mkvmlinuz <none>
Versions of packages linux-image-3.10-rc5-powerpc is related to:
pn firmware-atheros <none>
pn firmware-bnx2 <none>
pn firmware-bnx2x <none>
pn firmware-brcm80211 <none>
pn firmware-intelwimax <none>
pn firmware-ipw2x00 <none>
pn firmware-ivtv <none>
pn firmware-iwlwifi <none>
pn firmware-libertas <none>
pn firmware-linux <none>
pn firmware-linux-nonfree <none>
pn firmware-myricom <none>
pn firmware-netxen <none>
pn firmware-qlogic <none>
pn firmware-ralink <none>
pn firmware-realtek <none>
pn xen-hypervisor <none>
-- debconf information:
linux-image-3.10-rc5-powerpc/postinst/missing-firmware-3.10-rc5-powerpc:
linux-image-3.10-rc5-powerpc/postinst/ignoring-ramdisk:
linux-image-3.10-rc5-powerpc/prerm/removing-running-kernel-3.10-rc5-powerpc:
true
linux-image-3.10-rc5-powerpc/postinst/depmod-error-initrd-3.10-rc5-powerpc:
false
--
To UNSUBSCRIBE, email to debian-kernel-requ...@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org
Archive:
http://lists.debian.org/20130624121734.2377.34247.report...@clam.lair.fifthhorseman.net
