On Sat, 22 Oct 2011, Ben Hutchings wrote: > On Fri, 2011-10-21 at 20:02 +0200, Mark Wahl wrote: > [...] > > > > (3c59X does not support ethtool, therefore the module parameter is needed) > > > > Correct function could be checked by active LEDs on ethernet-connector > > after power-off. > [...] > > Does wake-on-LAN work if you suspend/hibernate the system? > > Ben. Hi Ben,
I didn't use hibernate on this system before, so I cannot say whether it worked there with lenny. But I just tried to hibernate (to disk) in squeeze (kernel 2.6.32-5-686 with command hibernate) and hibernate/resume worked correctly, but wake-on-LAN does not work (like in power-off case). The LEDs at the ethernet-connector are off and the system does not start on a magic packet. Then I checked "hibernate-ram" (to ram) with the same configuration. There I had a little problem that the video-output (just console, no X installed on system) was not active after resume (which might be corrected by some specific resume-hooks), but the rest of the system was operational. In addition wake-on-LAN worked, the LEDs were active and I could resume the system from suspend to ram with the magic packet. So the problem occurs only when the system is powered off completely. Bye, Mark -- To UNSUBSCRIBE, email to debian-kernel-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org Archive: http://lists.debian.org/pine.lnx.4.58.1110221458550.7...@dl4ybg.local.priv
