On Fri, Oct 07, 2011 at 02:29:06PM +0300, Touko Korpela wrote: > On Thu, Oct 06, 2011 at 09:57:05PM -0300, Henrique de Moraes Holschuh wrote: > > Nowadays we're supposed to trust the kernel to do it right, and your disk > > should spin up only if it has crap firmware (unlikely). Unless you're using > > the deprecated "old ide" drivers (/dev/hd*), in which case all bets are off. > > > > Please edit /etc/init.d/halt and make it not add "-h" to the halt invocation > > (but make sure to add "sync ; sleep 5" before the halt command just in > > case). Does that fix the issue? > > It doesn't make a difference. So maybe it's a kernel issue then. > Same happens with another laptop that has Hitachi HTS54502 disk, so this > issue is more common. This has a Seagate disk. > > Here is some lines from kernel 3.0.0-1-amd64 (Debian 3.0.0-3) boot dmesg. > > [ 1.425212] Block layer SCSI generic (bsg) driver version 0.4 loaded > (major 253) > [ 1.651042] SCSI subsystem initialized > [ 1.681254] ahci 0000:00:11.0: AHCI 0001.0200 32 slots 1 ports 3 Gbps 0x1 > impl SATA mode > [ 1.690438] scsi0 : ahci > [ 1.690697] ata1: SATA max UDMA/133 abar m1024@0xfeb4c000 port 0xfeb4c100 > irq 19 > [ 2.196281] ata1: SATA link up 3.0 Gbps (SStatus 123 SControl 300) > [ 2.504191] ata1.00: ATA-8: ST9500325AS, 0003SDM1, max UDMA/133 > [ 2.504199] ata1.00: 976773168 sectors, multi 16: LBA48 NCQ (depth 31/32) > [ 2.506494] ata1.00: configured for UDMA/133 > [ 2.507008] scsi 0:0:0:0: Direct-Access ATA ST9500325AS > 0003 PQ: 0 ANSI: 5 > [ 2.517044] scsi1 : usb-storage 2-2:1.0 > [ 2.518624] sd 0:0:0:0: [sda] 976773168 512-byte logical blocks: (500 > GB/465 GiB) > [ 2.518751] sd 0:0:0:0: [sda] Write Protect is off > [ 2.518757] sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00 > [ 2.518810] sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, > doesn't support DPO or FUA > [ 2.548221] sda: sda1 sda2 sda3 sda4 > [ 2.549024] sd 0:0:0:0: [sda] Attached SCSI disk > [ 3.650505] scsi 1:0:0:0: Direct-Access Multiple Card Reader > 1.00 PQ: 0 ANSI: 0 > [ 4.608143] sd 1:0:0:0: [sdb] Attached SCSI removable disk
Here is missing ahci lines from that dmesg [ 1.681098] ahci 0000:00:11.0: version 3.0 [ 1.681139] ahci 0000:00:11.0: PCI INT A -> GSI 19 (level, low) -> IRQ 19 [ 1.681262] ahci 0000:00:11.0: flags: 64bit ncq sntf ilck pm led clo pmp pio slum part -- To UNSUBSCRIBE, email to debian-kernel-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org Archive: http://lists.debian.org/20111007122559.GA27624@tiikeri.vuoristo.local
