Package: linux-image-2.6-xen-amd64
Version: 2.6.32+28
Severity: normal
Hi,
with debian squeeze kernel my Sky2PC/SkyStar 2 DVB-S rev 2.6 is not able to
scan for channels. It's the same in arch i386 and amd64. When i use the stable
Lenny kernel everything is ok. The modules are loaded sucessfully, but i'm
not able to scan for channels. Attached you can find the output of dmesg,
lspci-vv and scan.
dmesg:
[ 1.458718] udev: starting version 160
[ 1.914121] input: PC Speaker as /devices/platform/pcspkr/input/input1
[ 1.994384] Error: Driver 'pcspkr' is already registered, aborting...
[ 2.107652] b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip
loaded successfully
[ 2.117598] flexcop-pci: will use the HW PID filter.
[ 2.117653] flexcop-pci: card revision 2
[ 2.117682] b2c2_flexcop_pci 0000:00:00.0: enabling device (0000 -> 0003)
[ 2.117777] b2c2_flexcop_pci 0000:00:00.0: Xen PCI enabling IRQ: 21
[ 2.117791] alloc irq_desc for 21 on node 0
[ 2.117794] alloc kstat_irqs on node 0
[ 2.132209] DVB: registering new adapter (FlexCop Digital TV device)
[ 2.134257] b2c2-flexcop: MAC address = 00:d0:d7:12:34:b0
[ 2.134848] CX24123: cx24123_i2c_readreg: reg=0x0 (error=-121)
[ 2.134855] CX24123: wrong demod revision: 87
[ 2.369535] b2c2-flexcop: found 'ST STV0299 DVB-S' .
[ 2.369549] DVB: registering adapter 0 frontend 0 (ST STV0299 DVB-S)...
[ 2.369620] b2c2-flexcop: initialization of 'Sky2PC/SkyStar 2 DVB-S rev 2.6'
at the 'PCI' bus controlled by a 'FlexCopIIb' complete
[ 2.492035] Adding 2097144k swap on /dev/xvda1. Priority:-xtents:1
across:2097144k SS
[ 2.619564] EXT3 FS on xvda2, internal journal
lspci-vv:
lspci -vv
00:00.0 Network controller: Techsan Electronics Co Ltd B2C2 FlexCopII DVB chip
/ Technisat SkyStar2 DVB card (rev 02)
Subsystem: Techsan Electronics Co Ltd B2C2 FlexCopII DVB chip /
Technisat SkyStar2 DVB card
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx-
Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort-
<MAbort- >SERR- <PERR- INTx-
Latency: 64
Interrupt: pin A routed to IRQ 21
Region 0: Memory at feaf0000 (32-bit, non-prefetchable) [size=64K]
Region 1: I/O ports at bc00 [size=32]
Kernel driver in use: b2c2_flexcop_pci
scan:
scan /usr/share/dvb/dvb-s/Astra-19.2E > /tmp/channels.conf
scanning /usr/share/dvb/dvb-s/Astra-19.2E/dvb-s/Astra-19.2E >
/tmp/channels.conf
using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0'
initial transponder 12551500 V 22000000 5
>>> tune to: 12551:v:0:22000
DVB-S IF freq is 1951500
WARNING: filter timeout pid 0x0011
WARNING: filter timeout pid 0x0000
WARNING: filter timeout pid 0x0010
dumping lists (0 services)
Done.
Thanks in advance,
regards
Herbert
-- System Information:
Debian Release: squeeze/sid
APT prefers testing
APT policy: (500, 'testing')
Architecture: amd64 (x86_64)
Kernel: Linux 2.6.32-5-xen-amd64 (SMP w/1 CPU core)
Locale: LANG=C, LC_CTYPE=C (charmap=ANSI_X3.4-1968)
Shell: /bin/sh linked to /bin/dash
Versions of packages linux-image-2.6-xen-amd64 depends on:
ii linux-image-2.6.32-5-xen-amd6 2.6.32-20 Linux 2.6.32 for 64-bit PCs, Xen d
linux-image-2.6-xen-amd64 recommends no packages.
linux-image-2.6-xen-amd64 suggests no packages.
-- no debconf information
--
To UNSUBSCRIBE, email to debian-kernel-requ...@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org
Archive:
http://lists.debian.org/20100902073653.977.42234.report...@mythtvbackend.lueger.or.at
