Your message dated Thu, 10 Dec 2009 22:43:13 +0100
with message-id <20091210214313.ga4...@galadriel.inutil.org>
and subject line Re: Wired network connection shuts down every 4-5min, then
automaticaly restarts
has caused the Debian Bug report #530551,
regarding Wired network connection shuts down every 4-5min, then automaticaly
restarts
to be marked as done.
This means that you claim that the problem has been dealt with.
If this is not the case it is now your responsibility to reopen the
Bug report if necessary, and/or fix the problem forthwith.
(NB: If you are a system administrator and have no idea what this
message is talking about, this may indicate a serious mail system
misconfiguration somewhere. Please contact ow...@bugs.debian.org
immediately.)
--
530551: http://bugs.debian.org/cgi-bin/bugreport.cgi?bug=530551
Debian Bug Tracking System
Contact ow...@bugs.debian.org with problems
--- Begin Message ---
Package: base
Version: 5.0
Every 4-5 minutes the wired network connection shuts down. After a couple of
seconds it back on again. Log text:
May 25 19:22:23 Slejpner kernel: [ 3266.373370] ACPI: PCI Interrupt
0000:10:00.0[A] -> GSI 17 (level, low) -> IRQ 17
May 25 19:22:23 Slejpner kernel: [ 3266.373370] iwl3945: Radio disabled by HW
RF Kill switch
May 25 19:22:23 Slejpner kernel: [ 3266.373370] ACPI: PCI interrupt for device
0000:10:00.0 disabled
May 25 19:22:23 Slejpner pppd[4761]: Modem hangup
May 25 19:22:23 Slejpner kernel: [ 3266.378069] eth0: late interrupt.
May 25 19:22:23 Slejpner kernel: [ 3266.380211] b44: eth0: powering down PHY
May 25 19:22:23 Slejpner pppd[4761]: Connect time 4.6 minutes.
May 25 19:22:23 Slejpner pppd[4761]: Sent 273611 bytes, received 1097617 bytes.
May 25 19:22:23 Slejpner pppd[4761]: Connection terminated.
May 25 19:22:23 Slejpner kernel: [ 3266.547179] ACPI: PCI Interrupt
0000:10:00.0[A] -> GSI 17 (level, low) -> IRQ 17
May 25 19:22:23 Slejpner kernel: [ 3266.547179] iwl3945: Radio disabled by HW
RF Kill switch
May 25 19:22:23 Slejpner kernel: [ 3266.547179] ACPI: PCI interrupt for device
0000:10:00.0 disabled
May 25 19:22:23 Slejpner kernel: [ 3266.553069] ADDRCONF(NETDEV_UP): eth0: link
is not ready
May 25 19:22:23 Slejpner kernel: [ 3266.662871] b44: eth0: powering down PHY
May 25 19:22:24 Slejpner kernel: [ 3267.870455] ADDRCONF(NETDEV_UP): eth0: link
is not ready
May 25 19:22:28 Slejpner kernel: [ 3271.219899] b44: eth0: Link is up at 100
Mbps, full duplex.
May 25 19:22:28 Slejpner kernel: [ 3271.219909] b44: eth0: Flow control is off
for TX and off for RX.
May 25 19:22:28 Slejpner kernel: [ 3271.220250] ADDRCONF(NETDEV_CHANGE): eth0:
link becomes ready
May 25 19:22:53 Slejpner pppd[4761]: PPP session is 3757
May 25 19:22:53 Slejpner pppd[4761]: Using interface ppp0
May 25 19:22:53 Slejpner pppd[4761]: Connect: ppp0 <--> eth0
May 25 19:22:53 Slejpner pppd[4761]: CHAP authentication succeeded
May 25 19:22:53 Slejpner pppd[4761]: CHAP authentication succeeded
May 25 19:22:53 Slejpner pppd[4761]: peer from calling number 00:90:1A:A0:F4:5A
authorized
May 25 19:22:54 Slejpner pppd[4761]: local IP address 78.54.111.171
May 25 19:22:54 Slejpner pppd[4761]: remote IP address 213.191.76.38
May 25 19:22:54 Slejpner pppd[4761]: primary DNS address 213.191.74.19
May 25 19:22:54 Slejpner pppd[4761]: secondary DNS address 62.109.123.197
Other stuff that might help:
a...@slejpner:~$ uname -a
Linux Slejpner 2.6.26-1-686 #1 SMP Sat Jan 10 18:29:31 UTC 2009 i686 GNU/Linux
a...@slejpner:~$
a...@slejpner:~$ ls -l /lib/libc.so.6
lrwxrwxrwx 1 root root 11 16. Mai 00:36 /lib/libc.so.6 -> libc-2.7.so
a...@slejpner:~$
a...@slejpner:~$ dpkg -s libc6 | grep ^Version
Version: 2.7-18
a...@slejpner:~$ reportbug -q --template -T none -s none -S normal -b --list-cc
none -q base
Detected character set: UTF-8
Please change your locale if this is incorrect.
Using 'Arne <mydebian.b...@web.de>' as your from address.
Getting status for base...
Will send report to Debian (per lsb_release).
Content-Type: text/plain; charset="us-ascii"
MIME-Version: 1.0
Content-Transfer-Encoding: 7bit
From: Arne <mydebian.b...@web.de>
To: Debian Bug Tracking System <sub...@bugs.debian.org>
Subject: none
X-Debbugs-Cc: mydebian.b...@web.de, none
Package: base
Severity: normal
-- System Information:
Debian Release: 5.0
APT prefers proposed-updates
APT policy: (99, 'proposed-updates'), (99, 'stable')
Architecture: i386 (i686)
Kernel: Linux 2.6.26-1-686 (SMP w/2 CPU cores)
Locale: LANG=de_DE.UTF-8, LC_CTYPE=de_DE.UTF-8 (charmap=UTF-8)
Shell: /bin/sh linked to /bin/bash
The system is running on a hp nx7400 laptop with 1 GB ram and 250 GB Samsung
Harddisk.
No problems what soever while using Etch.
Good Luck & thank you very much !
__________________________________________________________________________
Verschicken Sie SMS direkt vom Postfach aus - in alle deutschen und viele
ausländische Netze zum gleichen Preis!
https://produkte.web.de/webde_sms/sms
--- End Message ---
--- Begin Message ---
On Tue, Dec 08, 2009 at 11:39:06PM +0100, Moritz Muehlenhoff wrote:
> The next release of Debian (6.0, code name Squeeze) will be based
> on 2.6.32. Please test the current 2.6.32 from unstable and tell
> us whether the problem persists. If so, we should report it upstream
> to the kernel.org developers.
>
> The 2.6.32 kernel is available from packages.debian.org and can
> be installed in both Debian stable, testing and unstable
> installations.
The submitter's address bounces, closing.
Thanks,
Moritz
--- End Message ---
