Subject: linux-image-2.6.12-1-386: Module sym53c8xx: "phase change" messages on Iomega ZIP drive Package: linux-image-2.6.12-1-386 Version: 2.6.12-10 Severity: normal
As soon as during the boot procedure my Iomega SCSI ZIP drive is recognized I get the following message onto the console: sd 0:0:5:0 phase change 6-7 [EMAIL PROTECTED] resid=7. (the number [EMAIL PROTECTED] is different after each booting of the machine) This message is written about 5-10 times per second onto the console making working with it almost impossible. This was especially a problem during installation of the system. Inserting a disk into the ZIP drive improves the situation slightly: The amount of messages drops to about 1 per second - still too much. Despite of the messages, access to such a disk works correctly. Booting the machine with the ZIP drive powered off does not give the message. I located the above message in the linux kernel files: - /usr/src/linux-2.6-2.6.12/drivers/scsi/ncr53c8xx.c - /usr/src/linux-2.6-2.6.12/drivers/scsi/sym53c8xx_2/sym_hipd.c This bug seems to be closely related to #303088 Here is the relevant part of /var/log/messages: Dec 4 08:32:17 df8xq-l2 kernel: PCI: Found IRQ 9 for device 0000:00:13.0 Dec 4 08:32:17 df8xq-l2 kernel: PCI: Sharing IRQ 9 with 0000:00:11.2 Dec 4 08:32:17 df8xq-l2 kernel: sym0: <875> rev 0x4 at pci 0000:00:13.0 irq 9 Dec 4 08:32:17 df8xq-l2 kernel: sym0: Symbios NVRAM, ID 7, Fast-20, SE, parity checking Dec 4 08:32:17 df8xq-l2 kernel: sym0: open drain IRQ line driver, using on-chip SRAM Dec 4 08:32:17 df8xq-l2 kernel: sym0: using LOAD/STORE-based firmware. Dec 4 08:32:17 df8xq-l2 kernel: sym0: SCSI BUS has been reset. Dec 4 08:32:17 df8xq-l2 kernel: scsi0 : sym-2.2.0 Dec 4 08:32:17 df8xq-l2 kernel: Floppy drive(s): fd0 is 1.44M Dec 4 08:32:17 df8xq-l2 kernel: bt878: AUDIO driver version 0.0.0 loaded Dec 4 08:32:17 df8xq-l2 kernel: FDC 0 is a post-1991 82077 Dec 4 08:32:17 df8xq-l2 kernel: USB Universal Host Controller Interface driver v2.2 Dec 4 08:32:17 df8xq-l2 kernel: Vendor: TEAC Model: CD-R55S Rev: 1.0R Dec 4 08:32:17 df8xq-l2 kernel: Type: CD-ROM ANSI SCSI revision: 02 Dec 4 08:32:17 df8xq-l2 kernel: target0:0:1: Beginning Domain Validation Dec 4 08:32:17 df8xq-l2 kernel: target0:0:1: asynchronous. Dec 4 08:32:17 df8xq-l2 kernel: target0:0:1: Domain Validation skipping write tests Dec 4 08:32:17 df8xq-l2 kernel: target0:0:1: FAST-10 SCSI 10.0 MB/s ST (100 ns, offset 15) Dec 4 08:32:17 df8xq-l2 kernel: target0:0:1: Ending Domain Validation Dec 4 08:32:17 df8xq-l2 kernel: Vendor: IOMEGA Model: ZIP 100 Rev: E.08 Dec 4 08:32:17 df8xq-l2 kernel: Type: Direct-Access ANSI SCSI revision: 02 Dec 4 08:32:17 df8xq-l2 kernel: target0:0:5: Beginning Domain Validation Dec 4 08:32:17 df8xq-l2 kernel: 0:0:5:0: phase change 6-7 [EMAIL PROTECTED] resid=7. Dec 4 08:32:17 df8xq-l2 last message repeated 3 times Dec 4 08:32:17 df8xq-l2 kernel: target0:0:5: Ending Domain Validation Dec 4 08:32:17 df8xq-l2 kernel: uhci_hcd 0000:00:07.2: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller Dec 4 08:32:17 df8xq-l2 kernel: uhci_hcd 0000:00:07.2: new USB bus registered, assigned bus number 4 Dec 4 08:32:17 df8xq-l2 kernel: uhci_hcd 0000:00:07.2: irq 10, io base 0x0000e400 Dec 4 08:32:17 df8xq-l2 kernel: hub 4-0:1.0: USB hub found Dec 4 08:32:17 df8xq-l2 kernel: hub 4-0:1.0: 2 ports detected Dec 4 08:32:17 df8xq-l2 kernel: sr0: scsi-1 drive Dec 4 08:32:17 df8xq-l2 kernel: Attached scsi generic sg0 at scsi0, channel 0, id 1, lun 0, type 5 Dec 4 08:32:17 df8xq-l2 kernel: Attached scsi generic sg1 at scsi0, channel 0, id 5, lun 0, type 0 Dec 4 08:32:17 df8xq-l2 kernel: sd 0:0:5:0: phase change 6-7 [EMAIL PROTECTED] resid=7. Dec 4 08:32:17 df8xq-l2 kernel: sd 0:0:5:0: phase change 6-7 [EMAIL PROTECTED] resid=7. Dec 4 08:32:17 df8xq-l2 kernel: sd 0:0:5:0: phase change 6-7 [EMAIL PROTECTED] resid=7. Dec 4 08:32:17 df8xq-l2 kernel: sd 0:0:5:0: phase change 6-7 [EMAIL PROTECTED] resid=7. Dec 4 08:32:17 df8xq-l2 kernel: sd 0:0:5:0: phase change 6-7 [EMAIL PROTECTED] resid=7. Dec 4 08:32:17 df8xq-l2 kernel: sd 0:0:5:0: phase change 6-7 [EMAIL PROTECTED] resid=7. Dec 4 08:32:17 df8xq-l2 kernel: Attached scsi removable disk sda at scsi0, channel 0, id 5, lun 0 Dec 4 08:32:17 df8xq-l2 kernel: sd 0:0:5:0: phase change 6-7 [EMAIL PROTECTED] resid=7. Dec 4 08:32:17 df8xq-l2 kernel: sd 0:0:5:0: phase change 6-7 [EMAIL PROTECTED] resid=7. Dec 4 08:32:17 df8xq-l2 kernel: sd 0:0:5:0: phase change 6-7 [EMAIL PROTECTED] resid=7. Dec 4 08:32:17 df8xq-l2 kernel: sd 0:0:5:0: phase change 6-7 [EMAIL PROTECTED] resid=7. Dec 4 08:32:17 df8xq-l2 kernel: sd 0:0:5:0: phase change 6-7 [EMAIL PROTECTED] resid=7. Dec 4 08:32:17 df8xq-l2 kernel: sd 0:0:5:0: phase change 6-7 [EMAIL PROTECTED] resid=7. Dec 4 08:32:17 df8xq-l2 kernel: sd 0:0:5:0: phase change 6-7 [EMAIL PROTECTED] resid=7. Dec 4 08:32:17 df8xq-l2 kernel: sd 0:0:5:0: phase change 6-7 [EMAIL PROTECTED] resid=7. Dec 4 08:32:17 df8xq-l2 kernel: sd 0:0:5:0: phase change 6-7 [EMAIL PROTECTED] resid=7. Dec 4 08:32:17 df8xq-l2 kernel: sd 0:0:5:0: phase change 6-7 [EMAIL PROTECTED] resid=7. Dec 4 08:32:17 df8xq-l2 kernel: Device not ready. Make sure there is a disc in the drive. Dec 4 08:32:17 df8xq-l2 kernel: sd 0:0:5:0: phase change 6-7 [EMAIL PROTECTED] resid=7. Dec 4 08:32:17 df8xq-l2 kernel: sd 0:0:5:0: phase change 6-7 [EMAIL PROTECTED] resid=7. Dec 4 08:32:17 df8xq-l2 kernel: sd 0:0:5:0: phase change 6-7 [EMAIL PROTECTED] resid=7. -- System Information: Debian Release: testing/unstable Architecture: i386 (i586) Shell: /bin/sh linked to /bin/bash Kernel: Linux 2.6.12-1-386 Locale: [EMAIL PROTECTED], [EMAIL PROTECTED] (charmap=ISO-8859-15) Versions of packages linux-image-2.6.12-1-386 depends on: ii coreutils [fileutils] 5.2.1-2.1 The GNU core utilities ii initrd-tools 0.1.84 tools to create initrd image for p ii module-init-tools 3.2-pre9-4 tools for managing Linux kernel mo linux-image-2.6.12-1-386 recommends no packages. -- no debconf information -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
