Package: kernel-image-2.6.8-2-sparc64 Version: 2.6.8-15 Severity: normal This kernel fails to recognize all LVM RAID-1 devices. It will automatically detect md0 and md1, but fails to detect md2.
During bootup it therefore fails to mount the filesystem on this partition and drops to a console prompt. Running mdadm --assemble /dev/md2 /dev/sda5 /dev/sdb5 correctly recognizes and starts the md2 device, and I can bootup normally. All partitions are flagged as "Linux raid autodetect" and a 2.4 kernel picks them up automatically. Included "dmesg.txt" with the dmesg output; also "fdisk.txt" lists the disk partitions on the sda and sdb devices (identical). -- System Information: Debian Release: 3.1 Architecture: sparc (sparc64) Kernel: Linux 2.6.8-2-sparc64 Locale: LANG=C, LC_CTYPE=C (charmap=ANSI_X3.4-1968) Versions of packages kernel-image-2.6.8-2-sparc64 depends on: ii initrd-tools 0.1.81.1 tools to create initrd image for p ii module-init-tools 3.2-pre1-2 tools for managing Linux kernel mo -- no debconf information
PROMLIB: Sun IEEE Boot Prom 3.23.1 1999/07/16 12:08 Linux version 2.6.8-2-sparc64 ([EMAIL PROTECTED]) (gcc version 3.3.5 (Debian 1:3.3.5-12)) #1 Wed Mar 23 04:23:37 EST 2005 ARCH: SUN4U Ethernet address: 08:00:20:e1:b2:3e On node 0 totalpages: 130171 DMA zone: 130171 pages, LIFO batch:8 Normal zone: 0 pages, LIFO batch:1 HighMem zone: 0 pages, LIFO batch:1 Built 1 zonelists Kernel command line: root=/dev/md0 PID hash table entries: 4096 (order 12: 65536 bytes) Console: colour dummy device 80x25 Dentry cache hash table entries: 131072 (order: 7, 1048576 bytes) Inode-cache hash table entries: 65536 (order: 6, 524288 bytes) Memory: 1032000k available (1992k kernel code, 600k data, 152k init) [fffff80000000000,00000000bff1e000] Calibrating delay loop... 897.02 BogoMIPS Mount-cache hash table entries: 512 (order: 0, 8192 bytes) checking if image is initramfs...it isn't (ungzip failed); looks like an initrd Freeing initrd memory: 3128k freed NET: Registered protocol family 16 PCI: Probing for controllers. PCI: Found PSYCHO, control regs at 000001fe00000000 PSYCHO: Shared PCI config space at 000001fe01000000 PCI-IRQ: Routing bus[ 0] slot[ 1] map[0] to INO[21] PCI-IRQ: Routing bus[ 0] slot[ 3] map[0] to INO[20] PCI-IRQ: Routing bus[ 0] slot[ 3] map[0] to INO[26] PCI0(PBMB): Bus running at 33MHz PCI-IRQ: Routing bus[81] slot[ 0] map[1] to INO[01] PCI-IRQ: Routing bus[81] slot[ 1] map[1] to INO[02] PCI-IRQ: Routing bus[81] slot[ 2] map[1] to INO[03] PCI-IRQ: Routing bus[81] slot[ 3] map[1] to INO[00] PCI0(PBMA): Bus running at 33MHz ebus0: [auxio] [power] [SUNW,pll] [sc] [se] [su] [su] [ecpp] [fdthree] [eeprom] [flashprom] power: Control reg at 000001fff1724000 ... not using powerd. usbcore: registered new driver usbfs usbcore: registered new driver hub VFS: Disk quotas dquot_6.5.1 Dquot-cache hash table entries: 1024 (order 0, 8192 bytes) devfs: 2004-01-31 Richard Gooch ([EMAIL PROTECTED]) devfs: boot_options: 0x0 Initializing Cryptographic API Console: switching to mono PROM 80x34 rtc_init: no PC rtc found su0 at 0x000001fff13062f8 (irq = 4,7ea) is a 16550A su1 at 0x000001fff13083f8 (irq = 9,7e9) is a 16550A ttyS0 at MMIO 0x1fff1400000 (irq = 7125984) is a SAB82532 V3.2 ttyS1 at MMIO 0x1fff1400040 (irq = 7125984) is a SAB82532 V3.2 Console: ttyS0 (SAB82532) Using anticipatory io scheduler RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize loop: loaded (max 8 devices) Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx usbcore: registered new driver usbhid drivers/usb/input/hid-core.c: v2.0:USB HID core driver mice: PS/2 mouse device common for all mice input: Sun Mouse on su/serio0 NET: Registered protocol family 2 IP: routing cache hash table of 16384 buckets, 128Kbytes TCP: Hash tables configured (established 131072 bind 65536) NET: Registered protocol family 1 NET: Registered protocol family 17 RAMDISK: cramfs filesystem found at block 0 RAMDISK: Loading 3128 blocks [1 disk] into ram disk... |/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\done. VFS: Mounted root (cramfs filesystem) readonly. md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27 md: raid1 personality registered as nr 3 SCSI subsystem initialized sym0: <875> rev 0x14 at pci 0001:00:03.0 irq 4,7e0 sym0: No NVRAM, ID 7, Fast-20, SE, parity checking sym0: SCSI BUS has been reset. scsi0 : sym-2.1.18j Vendor: FUJITSU Model: MAN3184M SUN18G Rev: 1502 Type: Direct-Access ANSI SCSI revision: 02 sym0:0:0: tagged command queuing enabled, command queue depth 16. scsi(0:0:0:0): Beginning Domain Validation sym0:0: wide asynchronous. sym0:0: FAST-20 WIDE SCSI 40.0 MB/s ST (50.0 ns, offset 16) scsi(0:0:0:0): Ending Domain Validation Vendor: SEAGATE Model: ST318404LSUN18G Rev: 4203 Type: Direct-Access ANSI SCSI revision: 03 sym0:1:0: tagged command queuing enabled, command queue depth 16. scsi(0:0:1:0): Beginning Domain Validation sym0:1: wide asynchronous. sym0:1: FAST-20 WIDE SCSI 40.0 MB/s ST (50.0 ns, offset 16) scsi(0:0:1:0): Ending Domain Validation Vendor: TOSHIBA Model: XM6201TASUN32XCD Rev: 1103 Type: CD-ROM ANSI SCSI revision: 02 scsi(0:0:6:0): Beginning Domain Validation sym0:6: FAST-10 SCSI 10.0 MB/s ST (100.0 ns, offset 16) scsi(0:0:6:0): Domain Validation skipping write tests scsi(0:0:6:0): Ending Domain Validation sym1: <875> rev 0x14 at pci 0001:00:03.1 irq 4,7e6 sym1: No NVRAM, ID 7, Fast-20, SE, parity checking sym1: SCSI BUS has been reset. scsi1 : sym-2.1.18j SCSI device sda: 35378533 512-byte hdwr sectors (18114 MB) SCSI device sda: drive cache: write through /dev/scsi/host0/bus0/target0/lun0: p1 p2 p3 p4 p5 Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 SCSI device sdb: 35378533 512-byte hdwr sectors (18114 MB) SCSI device sdb: drive cache: write through /dev/scsi/host0/bus0/target1/lun0: p1 p2 p3 p4 p5 Attached scsi disk sdb at scsi0, channel 0, id 1, lun 0 md: md1 stopped. md: bind<sda2> md: bind<sdb2> raid1: raid set md1 active with 2 out of 2 mirrors md: md0 stopped. md: bind<sda4> md: bind<sdb4> raid1: raid set md0 active with 2 out of 2 mirrors VFS: Can't find ext3 filesystem on dev md0. VFS: Can't find ext2 filesystem on dev md0. ReiserFS: md0: found reiserfs format "3.6" with standard journal ReiserFS: md0: using ordered data mode ReiserFS: md0: journal params: device md0, size 8192, journal first block 18, max trans len 1024, max batch 900, max commit age 30, max trans age 30 ReiserFS: md0: checking transaction log (md0) ReiserFS: md0: Using r5 hash to sort names Adding 522928k swap on /dev/md1. Priority:-1 extents:1 md: md2 stopped. md: bind<sda5> md: bind<sdb5> raid1: raid set md2 active with 2 out of 2 mirrors ReiserFS: md2: found reiserfs format "3.6" with standard journal ReiserFS: md2: using ordered data mode ReiserFS: md2: journal params: device md2, size 8192, journal first block 18, max trans len 1024, max batch 900, max commit age 30, max trans age 30 ReiserFS: md2: checking transaction log (md2) ReiserFS: md2: Using r5 hash to sort names NET: Registered protocol family 10 Disabled Privacy Extensions on device 000000000064fb90(lo) IPv6 over IPv4 tunneling driver ip_tables: (C) 2000-2002 Netfilter core team ip_conntrack version 2.1 (4045 buckets, 32360 max) - 432 bytes per conntrack sunhme.c:v2.02 24/Aug/2003 David S. Miller (davem@redhat.com) eth0: HAPPY MEAL (PCI/CheerIO) 10/100BaseT Ethernet 08:00:20:e1:b2:3e eth1-4: Quattro HME (PCI/CheerIO) 10/100baseT Ethernet DEC 21153 PCI Bridge eth1: Quattro HME slot 0 (PCI/CheerIO) 10/100baseT Ethernet 08:00:20:f1:83:9c eth2: Quattro HME slot 1 (PCI/CheerIO) 10/100baseT Ethernet 08:00:20:f1:83:9d eth3: Quattro HME slot 2 (PCI/CheerIO) 10/100baseT Ethernet 08:00:20:f1:83:9e eth4: Quattro HME slot 3 (PCI/CheerIO) 10/100baseT Ethernet 08:00:20:f1:83:9f eth0: Link has been forced up using internal transceiver at 100Mb/s, Full Duplex. eth0: no IPv6 routers present
Disk /dev/sda (Sun disk label): 19 heads, 248 sectors, 7506 cylinders Units = cylinders of 4712 * 512 bytes Device Flag Start End Blocks Id System /dev/sda1 0 41 96596 83 Linux native /dev/sda2 41 263 523032 fd Linux raid autodetect /dev/sda3 u 0 7506 17684136 5 Whole disk /dev/sda4 263 1921 3906248 fd Linux raid autodetect /dev/sda5 1921 7500 13144124 fd Linux raid autodetect
