Hi Laszlo
You were right with the tip concerning "vga=..." in lilo.conf and disabling frame buffer support. I played around with different console settings and the only config that works correctly is: CONFIG_CONSOLE_VGA=y # CONFIG_FB is not set
Now I can see the boot messages. OK, about 30 lines on a 18-inch screen
are not really great and I miss the penguins, but it's better than to see nothing at all.
The last question is: where does this change between 2.6.10 and 2.6.11 come from?
Is it bcause of my ATI Radeon card or has PCI express support changed or something else?
Thanks a lot and Regards Hubert
-- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
