Package: kernel-image-2.6.10-1-k7-smp
Version: 2.6.10-6
Severity: important
I receive an error when attempting to enable DMA on any of
the non-SCSI drives on the system. This makes the system
unusable when burning CDs or doing any archiving. DMA works
fine if I boot a 2.4 Debian kernel or boot Knoppix with a
2.6 kernel.
[EMAIL PROTECTED] /home/kelleher [1] $ sudo hdparm /dev/hda
/dev/hda:
multcount = 0 (off)
IO_support = 0 (default 16-bit)
unmaskirq = 0 (off)
using_dma = 0 (off)
keepsettings = 0 (off)
readonly = 0 (off)
readahead = 256 (on)
geometry = 65535/16/63, sectors = 80418240, start = 0
[EMAIL PROTECTED] /home/kelleher [2] $
[EMAIL PROTECTED] /home/kelleher [2] $ sudo hdparm -d1 /dev/hda
/dev/hda:
setting using_dma to 1 (on)
HDIO_SET_DMA failed: Operation not permitted
using_dma = 0 (off)
[EMAIL PROTECTED] /home/kelleher [3] $
[EMAIL PROTECTED] /home/kelleher [3] $ lspci -vv
0000:00:00.0 Host bridge: Advanced Micro Devices [AMD] AMD-760 MP [IGD4-2P]
System Controller (rev 11)
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66MHz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort+ >SERR- <PERR-
Latency: 32
Region 0: Memory at f8000000 (32-bit, prefetchable) [size=64M]
Region 1: Memory at f4c00000 (32-bit, prefetchable) [size=4K]
Region 2: I/O ports at 1010 [disabled] [size=4]
Capabilities: <available only to root>
0000:00:01.0 PCI bridge: Advanced Micro Devices [AMD] AMD-760 MP [IGD4-2P] AGP
Bridge (prog-if 00 [Normal decode])
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap- 66MHz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 99
Bus: primary=00, secondary=01, subordinate=01, sec-latency=64
Memory behind bridge: f4000000-f48fffff
Prefetchable memory behind bridge: f6000000-f7ffffff
BridgeCtl: Parity- SERR- NoISA+ VGA+ MAbort- >Reset- FastB2B-
0000:00:07.0 ISA bridge: Advanced Micro Devices [AMD] AMD-768 [Opus] ISA (rev
05)
Control: I/O+ Mem+ BusMaster+ SpecCycle+ MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap- 66MHz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 0
0000:00:07.1 IDE interface: Advanced Micro Devices [AMD] AMD-768 [Opus] IDE
(rev 04) (prog-if 8a [Master SecP PriP])
Subsystem: Advanced Micro Devices [AMD] AMD-768 [Opus] IDE
Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 0
Region 4: I/O ports at f000 [size=16]
0000:00:07.3 Bridge: Advanced Micro Devices [AMD] AMD-768 [Opus] ACPI (rev 03)
Subsystem: Advanced Micro Devices [AMD] AMD-768 [Opus] ACPI
Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
0000:00:10.0 PCI bridge: Advanced Micro Devices [AMD] AMD-768 [Opus] PCI (rev
05) (prog-if 00 [Normal decode])
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap- 66MHz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort+ >SERR- <PERR-
Latency: 64
Bus: primary=00, secondary=02, subordinate=02, sec-latency=168
I/O behind bridge: 00002000-00002fff
Memory behind bridge: f4900000-f49fffff
BridgeCtl: Parity- SERR- NoISA+ VGA- MAbort- >Reset- FastB2B-
0000:01:05.0 VGA compatible controller: Matrox Graphics, Inc. MGA G550 AGP (rev
01) (prog-if 00 [VGA])
Subsystem: Matrox Graphics, Inc. Millennium G550 Dual Head DDR 32Mb
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 128 (4000ns min, 8000ns max), Cache Line Size: 0x10 (64 bytes)
Interrupt: pin A routed to IRQ 169
Region 0: Memory at f6000000 (32-bit, prefetchable) [size=32M]
Region 1: Memory at f4800000 (32-bit, non-prefetchable) [size=16K]
Region 2: Memory at f4000000 (32-bit, non-prefetchable) [size=8M]
Capabilities: <available only to root>
0000:02:00.0 USB Controller: Advanced Micro Devices [AMD] AMD-768 [Opus] USB
(rev 07) (prog-if 10 [OHCI])
Subsystem: Advanced Micro Devices [AMD] AMD-768 [Opus] USB
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR+
Latency: 64 (20000ns max)
Interrupt: pin D routed to IRQ 177
Region 0: Memory at f4900000 (32-bit, non-prefetchable) [size=4K]
0000:02:04.0 Multimedia audio controller: Creative Labs SB Live! EMU10k1 (rev
05)
Subsystem: Creative Labs CT4850 SBLive! Value
Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (500ns min, 5000ns max)
Interrupt: pin A routed to IRQ 185
Region 0: I/O ports at 2480 [size=32]
Capabilities: <available only to root>
0000:02:04.1 Input device controller: Creative Labs SB Live! MIDI/Game Port
(rev 05)
Subsystem: Creative Labs Gameport Joystick
Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 64
Region 0: I/O ports at 24a0 [size=8]
Capabilities: <available only to root>
0000:02:06.0 SCSI storage controller: Adaptec AHA-2940U2/U2W
Subsystem: Adaptec AHA-2940U2W SCSI Controller
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (9750ns min, 6250ns max), Cache Line Size: 0x10 (64 bytes)
Interrupt: pin A routed to IRQ 169
BIST result: 00
Region 0: I/O ports at 2000 [disabled] [size=256]
Region 1: Memory at f4901000 (64-bit, non-prefetchable) [size=4K]
Capabilities: <available only to root>
0000:02:08.0 Ethernet controller: 3Com Corporation 3c905C-TX/TX-M [Tornado]
(rev 78)
Subsystem: Tyan Computer Tiger MPX S2466 (3C920 Integrated Fast
Ethernet Controller)
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 80 (2500ns min, 2500ns max), Cache Line Size: 0x10 (64 bytes)
Interrupt: pin A routed to IRQ 177
Region 0: I/O ports at 2400 [size=128]
Region 1: Memory at f4902000 (32-bit, non-prefetchable) [size=128]
Capabilities: <available only to root>
[EMAIL PROTECTED] /home/kelleher [4] $
-- System Information:
Debian Release: 3.1
APT prefers unstable
APT policy: (500, 'unstable')
Architecture: i386 (i686)
Kernel: Linux 2.6.10-1-k7-smp
Locale: LANG=en_US, LC_CTYPE=en_US (charmap=ISO-8859-1)
Versions of packages kernel-image-2.6.10-1-k7-smp depends on:
ii coreutils [fileutils] 5.2.1-2 The GNU core utilities
ii initrd-tools 0.1.77 tools to create initrd image for p
ii module-init-tools 3.2-pre1-2 tools for managing Linux kernel mo
-- no debconf information
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
