I am trying to write an ISO file (sarge disk 1) to a CDRW device. k3b successfully writes the disk and is 99% through verifying it has written it correctly when it reports an error. This is repeatable.
Debugging output is not helpful - no indication that there has been a problem. Given that the failure is right at the end of the verify phase its almost as though there is either a mismatch on the length, or the cdrw is failing to write the last block, or similar. Anyone any ideas how to verify this further. (I can't even figure out how I can do a manual verification using command line tools - so even advice on how to do that would be useful). -- Alan Chandler [EMAIL PROTECTED] First they ignore you, then they laugh at you, then they fight you, then you win. --Gandhi
