On Tue, 2003-08-05 at 17:53, Tomās Núņez Lirola wrote: > I can read in the specifications that the card is "Dual, NC7781 PCI-X Gigabit > 10/100/1000", but I've not found anything like this in the kernel. A nearby > machine (also a dl360 g3) has RH installed, and it use Tigon3 driver (tg3), > and work properly. I tried the same kernel module, but altough it loads up > without any error (modprobe tg3, or adding it to /etc/modules), and it lets > me configure the card (ifconfig goes ok), after that I can not ping any host > (network is not accesible). > I mean, everything seems to be ok, but there is no result. > > Has everyone installed Debian on a Compaq Proliant DL360 G3? What ethernet > card did you configure?
Not DL360G3 but a couple DL380G3 which are almost identical, just a little bit bigger due to their 6 drive-bays instead of 2. I assume the Ethernet chipset is exactly the same as on a DL360G3. The tg3 driver worked just fine for me right out-of-the-box without any problems. Stupid question: Did you maybe confuse the interfaces? Try to listen with 'tcpdump' on one interface and see if there are ANY packets incoming. Even with wrong IP-addresses or routing you should see traffic from others hosts on the same network (at least their broadcasts)... best regards, Markus -- Markus Oswald <[EMAIL PROTECTED]> \ Unix and Network Administration Graz, AUSTRIA \ High Availability / Cluster Mobile: +43 676 6485415 \ System Consulting Fax: +43 316 428896 \ Web Development -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
