Jonathan Daugherty wrote:
The hurd install guides say that I must watch carefully during boot to see if my network card (a linksys card) is detected. Is there no log which I can check for the same messages?
We have /dev/klog. It can be read only once. So do cat /dev/klog > boot.log Hit Ctrl-C afeter some seconds. (of course: Read the log ;-) )
That is, ifconfig shows no interfaces other than lo. If mach does not detect my card during boot, must I rebuild the kernel -- or is there a way to dynamically load a driver module?
GNUMach has no concept of kernel modules. Yes, you have to rebuild your kernel. But you can do this on a Linux system.
Patrick -- Engineers motto: | Patrick Strasser [ ] cheap | <past at sbox dot tugraz dot at> [ ] good | [ ] fast | Student of Telematik -> choose any two | Techn. University Graz, Austria
