On Mon, 2007-06-11 at 19:56 -0500, Mark Reitblatt wrote: > On 6/11/07, Alex Jones <[EMAIL PROTECTED]> wrote: > > Fine. Stick with Kilobytes, but strictly define it as 10^3 bytes. Just > > choose one over the other and be consistent. > > That's not "consistent". Kilobyte has always meant 2^10 bytes. "kilo" > in "kilobyte" is not an SI prefix. SI prefixes only apply to SI > measurements, of which "byte" is not a member. There is no confusion; > the only place where a kilobyte != 2^10 bytes is in hard drive > manufacturer's advertising materials. This is the way it has been for > decades, and it is a perfectly acceptable and desirable standard.
It's all not as simple as you write it. Bit rates have been usually measured in 10^(3x) bit per second, e.g. kbps or kbit/s. So when talking about transfer rates, kilo meant thousand. However, when talking about file/memory sizes, kilo meant 1024. But then again, a lot of people aren't aware of this difference and there are a lot of programs which present e.g. download speeds in 2^(10x) bytes per second (_bits_ per second are more common to be used in "lower levels", but there are also programs which use 2^10 _bits_ per second as transfer speed units). Another "historic" example is a floppy-MB: A 1.44MB floppy disc can store 1,474,560 Bytes, that is 1440 KiB and 1.40625 MiB or approximately 1475KB or 1.48MB with kilo=10^3 and mega=10^6. However, these floppies were known as "1.44MB"-floppies. (MB meaning 1000 times 1024 bytes). Very consistent! Your example of hard drive manufacturers is a another good example why we actually SHOULD have unambiguous prefixes. Advertising always tends to abuse ambiguities. When SI prefixes were used consistently, it would have been clear from start that you cannot fit 100 GiB of data on a hard drive advertised as having 100GB free space available. Just because something has been done wrong for a long time doesn't make it right. People who know the inconsistencies get used to them and do not want to change it because it may be inconvenient for them or it simply sounds stupid to them (what an argument!). However, this means that _every_ new generation of students and hobbyists has to go through learning the inconsistencies if we change nothing. Hooray, confusion till the end of times! But if we pushed the use of SI-prefixes, the computer-gurus would have to get used to the new system but following generations would profit from having a consistent unit system. In my opinion this is something that is worth the effort. The problem with such big changes is that a critical mass is needed to benefit from this new system and the faster it is achieved, the shorter the confusion-period will be. I think that the open source community should participate since consistent and unambiguous conventions are a good thing (TM). Christof Krüger
