Package: xen-utils-common
Version: 4.0.0-1
Hello guys,
Ik running Debian stable (squeeze).
This appeared in the messages when i started and stopped a DomU:
root@dom0:~# cat messages
Aug 31 22:04:52 dom0 kernel: [ 775.569937] device vif6.0 entered promiscuous
mode
Aug 31 22:04:52 dom0 kernel: [ 775.575993] br_lan: port 2(vif6.0) entering
forwarding state
Aug 31 22:04:52 dom0 kernel: [ 775.606023] physdev match: using --physdev-out
in the OUTPUT, FORWARD and POSTROUTING chains for non-bridged traffic is not
supported anymore.
Aug 31 22:04:53 dom0 kernel: [ 776.323952] blkback: ring-ref 8, event-channel
8, protocol 1 (x86_64-abi)
Aug 31 22:07:53 dom0 kernel: [ 955.709120] br_lan: port 2(vif6.0) entering
disabled state
Aug 31 22:07:53 dom0 kernel: [ 955.721359] br_lan: port 2(vif6.0) entering
disabled state
Aug 31 22:07:53 dom0 kernel: [ 955.790532] physdev match: using --physdev-out
in the OUTPUT, FORWARD and POSTROUTING chains for non-bridged traffic is not
supported anymore.
grep bridge /etc/xen/paradeb01.cfg
vif = [ 'mac=00:16:3E:0B:EE:5B, bridge=br_lan' ]
I run a virtual pfsense firwall in a DomU. I created multiple bridges.
The interfaces itself (except eth2 (connected to br_lan)) itself don't
have a IP assigned.
root@dom0:/etc/xen/scripts# cat /etc/xen/scripts/my-network-script
#!/bin/sh
dir=$(dirname "$0")
"$dir/network-bridge" "$@" vifnum=0 netdev=eth3 bridge=br_inet
"$dir/network-bridge" "$@" vifnum=1 netdev=eth2 bridge=br_lan
"$dir/network-bridge" "$@" vifnum=2 netdev=eth1 bridge=br_wlan
"$dir/network-bridge" "$@" vifnum=4 netdev=dummy0 bridge=br_dmz
If i start the firewall (connected to multiple bridges) i get a LOT of
those scary messages.
--
Best regards,
MisterE mailto:[email protected]
--
To UNSUBSCRIBE, email to [email protected]
with a subject of "unsubscribe". Trouble? Contact [email protected]
