Package: installation-reports Debian-installer-version: debian-amd64-testing netboot-cd (89 MB) snapshot 18/aug/2005 from cdimages.debian.org
uname -a: Linux (none) 2.6.12-1-amd64-generic #1 Fri Jul 22 18:12:08 CEST 2005 x86_64 unknown date: 19/aug/2005, 21:00 (vienna) method: boot from netinst-cd, "install acpi=off" Machine: Shuttle ST20G5 (Chipset ATI RS480/ULI M1573) Processor: AMD Athlon64 3000+ venice/939pin Memory: 2x512 MB Corsair Root Device: Samsung Spinpoint P120 250 GB SATA II Root Size/partition table: 1) used auto-partitioning (1 big / + 3 GB swap) - no problems 2) 2 GB Swap + 48 GB / + 200 GB /home, all primary - no problems Output of lspci: [sorry, since installation did not work I would have to copy manually... if you require additional info, please send me an email] initial boot worked: [O] configure network hw: [O] configure network: [E] - broadcom card did not work for dhcp manual conf required. but network is not working anyway (as I noticed using the rescue system; but I am sure that tg3 is correct, Knoppix works with it) Detect CD: [O] Load installer modules: [O] Detect hard drives: [E] - sata_uli/libata required and available, but not loaded automatically. even when prompted for drivers and after selecting "sata_uli" system says no HDD available (but hdd was recognized and identified correctly on scsi3; as I found on the output console!) run debian-installer hw-detect again (as reported last time)- then sata drive was found Do I miss something, do I need to load other drivers too?!; Partition hard drives: [O] - improved since last post Mount partitions: [O] - improved since last post Install base system: [O] Install boot loader: [O] Reboot: [E] - Grub works without any problem; but after loading the kernel I get: kernel panic (pivot_root: no such file or directory; /sbin/init: 432: cannot open dev/console: No such file; Kernel panic: Attempted to kill init! Comments/Problems: Without "acpi=off" --> instantanous kernel panic of the installer Code: 49 8b 91 f0 00 00 00 00 48 ff c1 49 8d 04 12 48 03 45 28 48 89 console shuts up ... not syncing: Aiee, killing interrupt handler! If during boot-procedure of the installer an USB-Stick is connected (what I did on error), the bootup freezes (obviously while detecting the USB-components). If removed, the bootup immediately continues and the language selection appears. -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
