Package: kismet
Version: 2008-05-R1-4.1
Severity: wishlist
File: /usr/share/doc/kismet/README.gz
At
2. Set up the capture sources. Most users will only need one, but it is
possible to have any number of sources defined which will be combined
into a single packet log.
Sources are defined with the 'source' directive. Source lines are
defined with 'source=type,interface,name[,channel]'. See the section
'Capture Sources' for a list of source types. The name can be anything
that is useful for you to identify what source it is. The initial
channel is optional. If an initial channel is requested on the command
line it will take precedence.
Or in /etc/kismet/kismet.conf
# Sources are defined as:
# source=sourcetype,interface,name[,initialchannel]
# Source types and required drivers are listed in the README under the
# CAPTURE SOURCES section.
# The initial channel is optional, if hopping is not enabled it can be used
# to set the channel the interface listens on.
# YOU MUST CHANGE THIS TO BE THE SOURCE YOU WANT TO USE
#source=none,none,addme
you need to add real examples, not just "none,none,addme"
Also say how to figure out the "interface".
E.g., "use iwconfig, dmesg etc. getting e.g., eth3"
--
To UNSUBSCRIBE, email to [email protected]
with a subject of "unsubscribe". Trouble? Contact [email protected]
