Package: installation-reports Boot method: network Image version: http://ftp.nl.debian.org/debian/dists/lenny/main/installer-i386/current/images/ Date: 2009-06-06 21:00
Machine: 82434 based Intel motherboard, answers to the name gort. Processor: Pentium 90 Memory: 64MB Partitions: Failed before then Output of lspci -knn (or lspci -nn): Base System Installation Checklist: [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Initial boot: [E] Detect network card: [ ] Configure network: [ ] Detect CD: [ ] Load installer modules: [ ] Detect hard drives: [ ] Partition hard drives: [ ] Install base system: [ ] Clock/timezone setup: [ ] User/password setup: [ ] Install tasks: [ ] Install boot loader: [ ] Overall install: [ ] Comments/Problems: The machine is an old Pentium 90 machine I use as a firewall; it seems to be running Etch OK but Lenny is failing very early. I'm netbooting it , it loads the pxe image and then I get a corrupt greeting screen (very blue lines, repeated multiple times with gaps in - looks like the whole image is maybe what should be one line of pixels is say 8 deep with black between). Anyway, that turns out to be minor, hitting the F keys get me the help text and I can load the kernel. I see it load and decompress the kernel then I see: Parsing ELF done <another line of text here that disappears too quickly> and then it reboots to the BIOS. That's repeatable. I think the same behaviour happened when I tried to run the USB/hard drive boot image off a partition on the hard disc, but I can't repeat that test now. Hardware: Trident ISA VGA card 1024MB RAM ISA Serial/parallel IO card AMI Bios 1.00.03.AX1Z lspci captured on etch: 00:00.0 Host bridge [0600]: Intel Corporation 82434LX/NX [Mercury/Neptune] Processor to PCI bridge [8086:04a3] (rev 11) 00:01.0 IDE interface [0101]: Micron PC Tech RZ1000 [1042:1000] (rev 01) 00:02.0 Non-VGA unclassified device [0000]: Intel Corporation 82378ZB/IB, 82379AB (SIO, SIO.A) PCI to ISA Bridge [8086:0484] (rev 03) 00:06.0 Ethernet controller [0200]: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ [10ec:8139] (rev 10) 00:0c.0 Ethernet controller [0200]: Intel Corporation 82557/8/9 [Ethernet Pro 100] [8086:1229] (rev 08) 00:0e.0 Ethernet controller [0200]: 3Com Corporation 3c905C-TX/TX-M [Tornado] [10b7:9200] (rev 74) dmesg captured on etch: Linux version 2.6.18-6-486 (Debian 2.6.18.dfsg.1-24) (da...@debian.org) (gcc version 4.1.2 20061115 (prerelease) (Debian 4.1.1-21)) #1 Sat Dec 27 08:57:46 UTC 2008 BIOS-provided physical RAM map: BIOS-88: 0000000000000000 - 000000000009f000 (usable) BIOS-88: 0000000000100000 - 0000000004000000 (usable) 64MB LOWMEM available. On node 0 totalpages: 16384 DMA zone: 4096 pages, LIFO batch:0 Normal zone: 12288 pages, LIFO batch:3 DMI not present or invalid. ACPI: Unable to locate RSDP Allocating PCI resources starting at 10000000 (gap: 04000000:fc000000) Detected 90.204 MHz processor. Built 1 zonelists. Total pages: 16384 Kernel command line: root=/dev/hda3 ro No local APIC present or hardware disabled mapped APIC to ffffd000 (01081000) Initializing CPU#0 PID hash table entries: 512 (order: 9, 2048 bytes) Console: colour VGA+ 80x25 Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) Memory: 57648k/65536k available (1501k kernel code, 7432k reserved, 601k data, 256k init, 0k highmem) Checking if this processor honours the WP bit even in supervisor mode... Ok. Calibrating delay using timer specific routine.. 181.01 BogoMIPS (lpj=362028) Security Framework v1.0.0 initialized SELinux: Disabled at boot. Capability LSM initialized Mount-cache hash table entries: 512 CPU: After generic identify, caps: 000001bf 00000000 00000000 00000000 00000000 00000000 00000000 CPU: After vendor identify, caps: 000001bf 00000000 00000000 00000000 00000000 00000000 00000000 Intel Pentium with F0 0F bug - workaround enabled. CPU: After all inits, caps: 000001bf 00000000 00000000 00000000 00000000 00000000 00000000 Compat vDSO mapped to ffffe000. CPU: Intel Pentium 75 - 200 stepping 04 Checking 'hlt' instruction... OK. checking if image is initramfs... it is Freeing initrd memory: 4245k freed NET: Registered protocol family 16 EISA bus registered PCI: PCI BIOS revision 2.00 entry at 0xf3940, last bus=0 PCI: Using configuration type 2 Setting up standard PCI resources ACPI: Interpreter disabled. Linux Plug and Play Support v0.97 (c) Adam Belay pnp: PnP ACPI: disabled PnPBIOS: Scanning system for PnP BIOS support... PnPBIOS: PnP BIOS support was not detected. PCI: Probing PCI hardware PCI: Probing PCI hardware (bus 00) PCI: Ignoring BAR0-1 of IDE controller 0000:00:01.0 PCI: Firmware left 0000:00:0c.0 e100 interrupts enabled, disabling NET: Registered protocol family 2 IP route cache hash table entries: 512 (order: -1, 2048 bytes) TCP established hash table entries: 2048 (order: 1, 8192 bytes) TCP bind hash table entries: 1024 (order: 0, 4096 bytes) TCP: Hash tables configured (established 2048 bind 1024) TCP reno registered audit: initializing netlink socket (disabled) audit(1244321790.148:1): initialized VFS: Disk quotas dquot_6.5.1 Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) Initializing Cryptographic API io scheduler noop registered io scheduler anticipatory registered io scheduler deadline registered io scheduler cfq registered (default) isapnp: Scanning for PnP cards... isapnp: No Plug & Play device found Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing enabled serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A serial8250: ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A serial8250: ttyS2 at I/O 0x3e8 (irq = 4) is a 16550A serial8250: ttyS3 at I/O 0x2e8 (irq = 3) is a 16550A RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize PNP: No PS/2 controller found. Probing ports directly. serio: i8042 AUX port at 0x60,0x64 irq 12 serio: i8042 KBD port at 0x60,0x64 irq 1 mice: PS/2 mouse device common for all mice EISA: Probing bus 0 at eisa.0 EISA: Detected 0 cards. TCP bic registered NET: Registered protocol family 1 NET: Registered protocol family 17 NET: Registered protocol family 8 NET: Registered protocol family 20 Using IPI Shortcut mode Time: tsc clocksource has been installed. Freeing unused kernel memory: 256k freed input: AT Translated Set 2 keyboard as /class/input/input0 Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx RZ100x: IDE controller at PCI slot 0000:00:01.0 RZ100x: chipset revision 1 RZ100x: not 100% native mode: will probe irqs later ide0: disabled chipset read-ahead (buggy RZ1000/RZ1001) ide1: disabled chipset read-ahead (buggy RZ1000/RZ1001) Probing IDE interface ide0... 8139too Fast Ethernet driver 0.9.27 e100: Intel(R) PRO/100 Network Driver, 3.5.10-k2-NAPI e100: Copyright(c) 1999-2005 Intel Corporation hda: IBM-DCAA-33610, ATA DISK drive hdb: GCD-R542B, ATAPI CD/DVD-ROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 Probing IDE interface ide1... eth0: RealTek RTL8139 at 0xfc80, 00:20:18:88:7a:c1, IRQ 11 eth0: Identified 8139 chip type 'RTL-8139 rev K' e100: eth1: e100_probe: addr 0xffbef000, irq 11, MAC addr 00:D0:B7:BF:81:57 3c59x: Donald Becker and others. www.scyld.com/network/vortex.html 0000:00:0e.0: 3Com PCI 3c905C Tornado at c4834f80. 8139cp: 10/100 PCI Ethernet driver v1.2 (Mar 22, 2004) hda: max request size: 128KiB hda: 7056000 sectors (3612 MB) w/96KiB Cache, CHS=7000/16/63 hda: cache flushes not supported hda: hda1 hda2 < hda5 > hda3 hdb: ATAPI 4X CD-ROM drive, 256kB Cache Uniform CD-ROM driver Revision: 3.20 Attempting manual resume kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. input: PC Speaker as /class/input/input1 Adding 176672k swap on /dev/hda5. Priority:-1 extents:1 across:176672k EXT3 FS on hda3, internal journal loop: loaded (max 8 devices) device-mapper: ioctl: 4.7.0-ioctl (2006-06-24) initialised: dm-de...@redhat.com kjournald starting. Commit interval 5 seconds EXT3 FS on hda1, internal journal EXT3-fs: mounted filesystem with ordered data mode. e100: eth1: e100_watchdog: link up, 100Mbps, full-duplex -- -----Open up your eyes, open up your mind, open up your code ------- / Dr. David Alan Gilbert | Running GNU/Linux on Alpha,68K| Happy \ \ gro.gilbert @ treblig.org | MIPS,x86,ARM,SPARC,PPC & HPPA | In Hex / \ _________________________|_____ http://www.treblig.org |_______/ -- To UNSUBSCRIBE, email to debian-bugs-dist-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org
