Package: installation-reports
Boot method: CD
Image version: cdimage.debian.org i386 beta3 netinst and
i386 daily netinst 20060905
Date: September 08, 2006
Machine: Home built A7V600
Processor: AMD 2500 MP
Memory: (2) 512mb = 1gb total
Partitions:
Disk /dev/hda: 40.0 GB, 40020664320 bytes
16 heads, 63 sectors/track, 77545 cylinders
Units = cylinders of 1008 * 512 = 516096 bytes
Device Boot Start End Blocks Id System
/dev/hda1 * 1 195 98248+ 83 Linux
/dev/hda2 196 1940 879480 82 Linux swap
/dev/hda3 1941 19380 8789760 83 Linux
/dev/hda4 19381 77545 29315160 5 Extended
/dev/hda5 19381 25194 2930224+ 83 Linux
/dev/hda6 25195 27133 977224+ 83 Linux
/dev/hda7 27134 31009 1953472+ 83 Linux
/dev/hda8 31010 36823 2930224+ 83 Linux
/dev/hda9 36824 40699 1953472+ 83 Linux
/dev/hda10 40700 46513 2930224+ 83 Linux
/dev/hda11 46514 62015 7812976+ 83 Linux
/dev/hda12 62016 77545 7827088+ 83 Linux
Output of lspci and lspci -n:
0000:00:00.0 Host bridge: VIA Technologies, Inc. VT8377 [KT400/KT600
AGP] Host Bridge (rev 80)
0000:00:01.0 PCI bridge: VIA Technologies, Inc. VT8237 PCI Bridge
0000:00:09.0 Ethernet controller: 3Com Corporation 3c940
10/100/1000Base-T [Marvell] (rev 12)
0000:00:0f.0 RAID bus controller: VIA Technologies, Inc. VIA VT6420 SATA
RAID Controller (rev 80)
0000:00:0f.1 IDE interface: VIA Technologies, Inc.
VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06)
0000:00:10.0 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB
1.1 Controller (rev 81)
0000:00:10.1 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB
1.1 Controller (rev 81)
0000:00:10.2 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB
1.1 Controller (rev 81)
0000:00:10.3 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB
1.1 Controller (rev 81)
0000:00:10.4 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 86)
0000:00:11.0 ISA bridge: VIA Technologies, Inc. VT8237 ISA bridge
[K8T800 South]0000:00:11.5 Multimedia audio controller: VIA
Technologies, Inc. VT8233/A/8235/8237 AC97 Audio Controller (rev 60)
0000:01:00.0 VGA compatible controller: ATI Technologies Inc RV280
[Radeon 9200] (rev 01)
0000:01:00.1 Display controller: ATI Technologies Inc RV280 [Radeon
9200] (Secondary) (rev 01)
0000:00:00.0 0600: 1106:3189 (rev 80)
0000:00:01.0 0604: 1106:b198
0000:00:09.0 0200: 10b7:1700 (rev 12)
0000:00:0f.0 0104: 1106:3149 (rev 80)
0000:00:0f.1 0101: 1106:0571 (rev 06)
0000:00:10.0 0c03: 1106:3038 (rev 81)
0000:00:10.1 0c03: 1106:3038 (rev 81)
0000:00:10.2 0c03: 1106:3038 (rev 81)
0000:00:10.3 0c03: 1106:3038 (rev 81)
0000:00:10.4 0c03: 1106:3104 (rev 86)
0000:00:11.0 0601: 1106:3227
0000:00:11.5 0401: 1106:3059 (rev 60)
0000:01:00.0 0300: 1002:5961 (rev 01)
0000:01:00.1 0380: 1002:5941 (rev 01)
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot worked: [E]
Configure network HW: [ ]
Config network: [ ]
Detect CD: [E]
Load installer modules: [ ]
Detect hard drives: [ ]
Partition hard drives: [ ]
Create file systems: [ ]
Mount partitions: [ ]
Install base system: [ ]
Install boot loader: [ ]
Reboot: [ ]
Comments/Problems:
The CD drive appears to not have been found with either beta3 or daily
(20060905) netinstall images. The failure message was:
"Disk boot failure, insert system disk and press return."
The md5sum for the daily image is good. Using an old beta1 image, the
CD drive was detected and showed the initial boot screen.
The CD drive is on hdc: LITE-ON COMBO LTC-48161H, ATAPI CD/DVD-ROM drive
and is using the IDE controller. The motherboard (A7V600) does have
SATA capability but is not used currently. I don't know if there is a
complete separation of SATA and IDE on the motherboard.
I would be willing to try http://wiki.debian.org/DebianInstaller/Modify
if I knew what I should try to change.
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
