* Joey Hess <[EMAIL PROTECTED]> [20060814 23:14]: > Thomas Arendsen Hein wrote: > > I booted d-i etch beta3 (full CD, x86) in "expert" mode. > > The system has two S-ATA disks (sda and sdb). > > > > When playing around with the installer I deleted two existing RAID > > partitions and recreated them. d-i detected existing data (a LVM pv) > > on the RAID partition and I deleted it and created a new one in the > > same place. > > > > Now the installer presented me an error message that it can't access > > the device "/dev/md/0p1". The device /dev/md/0 existed. > > You seem to be trying to create a partition on top of a RAID device. As > far as I know there is no standard way to do that (except for using LVM > over RAID). > > Instead you should have the partitioner use the whole raid device for a > filesystem.
As I wrote, I configured them as LVM physical volumes during the previous run of the same d-i CD. > Since I'm not clear from your description exactly what you're doing (the > use of unclear terms like "RAID partitions" doesn't help), I can't be > more specific. This unclear term is taken from the wording of d-i. Here the exact steps until the problem showed up: 1. I used nothing else than the d-i partition tool on these hard disks and the hardware doesn't provide any RAID specific support. 2. I created two partitions (type fd) to be used for software RAID and combined them to a RAID1 /dev/md0 device, but the d-i CD uses devfs, so it is visible as /dev/md/0 there. 3. I used this /dev/md/0 as a physical volume for LVM. 4. Because of an install problem (Debian bug #382692) I had to reboot. 5. To make a clean start for the next try I decided to delete (but not erase==wipe) the software==md RAID partitions. 6. Repeating from step 2 the installer presented me with the above mentioned error message. Thomas -- Email: [EMAIL PROTECTED] http://intevation.de/~thomas/
pgpKgco6a1LBH.pgp
Description: PGP signature
