here is the output of today dmesg [plugged the usb key] usb 1-1: new full speed USB device using address 2 SCSI subsystem initialized Initializing USB Mass Storage driver... scsi0 : SCSI emulation for USB Mass Storage devices Vendor: Model: Rev: 2.00 Type: Direct-Access ANSI SCSI revision: 02 USB Mass Storage device found at 2 usbcore: registered new driver usb-storage USB Mass Storage support registered. SCSI device sda: 2040319 512-byte hdwr sectors (1045 MB) sda: assuming Write Enabled sda: assuming drive cache: write through /dev/scsi/host0/bus0/target0/lun0: unknown partition table Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0 usb 1-1: USB disconnect, address 2 [plugged the usb key a second time] usb 1-1: new full speed USB device using address 3 scsi1 : SCSI emulation for USB Mass Storage devices Vendor: Model: Rev: 2.00 Type: Direct-Access ANSI SCSI revision: 02 SCSI device sda: 2040319 512-byte hdwr sectors (1045 MB) sda: assuming Write Enabled sda: assuming drive cache: write through [attempted to mount the volume: mount blocks and does not get killed even by kill -9] /dev/scsi/host1/bus0/target0/lun0:SCSI error : <1 0 0 0> return code = 0x70000 end_request: I/O error, dev sda, sector 0 Buffer I/O error on device sda, logical block 0 SCSI error : <1 0 0 0> return code = 0x70000 end_request: I/O error, dev sda, sector 1 Buffer I/O error on device sda, logical block 1 SCSI error : <1 0 0 0> return code = 0x70000 end_request: I/O error, dev sda, sector 2 Buffer I/O error on device sda, logical block 2 SCSI error : <1 0 0 0> return code = 0x70000 end_request: I/O error, dev sda, sector 3 Buffer I/O error on device sda, logical block 3 SCSI error : <1 0 0 0> return code = 0x70000 end_request: I/O error, dev sda, sector 4 Buffer I/O error on device sda, logical block 4
-- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
