Le 06/04/2022 à 17:59, Brian Potkin a écrit :
On Wed 06 Apr 2022 at 16:49:30 +0200, alain wrote:
Le 06/04/2022 à 16:06, Brian Potkin a écrit :
Is the ENVY*directly* connected to a USB port on the computer?
yes it is directly connected via usb to the pc .
I thiught it is but was just checking.
when the printer is connected , it does not print at all .
the ipp-usb daemon detects the printer and is activee. That is good.
The avahi-browse and driverless commands do not work for the printer
nd they should.
How do you go on with 'http://127.0.0.1:60000' in a browser?
in system-config -printer , the thing you created (the icon "envy" like
your last command done it)
is well shown . but i can not print . even a test page .
the printer is not automatically recognized (not the case in bullseye
where it is very well recognized )
when i had the hplip installed , the icon "envy 5530 ..." was created
but has never gone to be functionnal .
is my printer too old ? do i have to change it ?
i set printer on , it says :
ipp-usb is not ready for this device
also i can't shut down the computer .
Just switch off ?
the printer never switches off and the pc never , too .
or after a very very very long time and i didn't wait more than 1 ou 2
minutes
(that's enough normally it is instantly )
to switch off the printer , i have to unplug it (mains and usb) , replug
it (mains only) ,
set it off (there it is ok) and replug it (usb) .
and , only in this case , it is ok for the pc .
with bullseye stable , all is ok , i have no problem . retested this
morning .
box bouygues (france)
Fast5330b-r1
serial : 124251137275525
firmware :20.8.6
Thank you. That clarifies that.
Cheers,
Brian.
