Source: lamarc
Version: 2.1.10.1+dfsg-1
Severity: important
Tags: upstream
Justification: fails to build from source
User: debian-h...@lists.debian.org
Usertags: hurd-i386
The build of lamarc for hurd-i386 (admittedly not a release
architecture) failed:
checking build system type... i686-pc-gnu
checking host system type... i686-pc-gnu
checking target system type... i686-pc-gnu
[...]
DO NOT CHECK THIS config.ac in, it has GUI_TOOLKIT and
LAMARC_CODE_OSTYPE hardwired for 10.7 mac
[...]
Here is error message from wx-config, in case that helps:
Default config is gtk2-unicode-3.0 No config found to match:
/usr/bin/wx-config --debug=no --toolkit=osx_cocoa --list in
/usr/lib/i386-gnu/wx/config Please install the desired library build, or
specify a different prefix where it may be found. If the library is not
installed you may call its wx-config directly by specifying its full path. Also
available in /usr: base-unicode-3.0 gtk2-unicode-3.0
*************************************************************
configure: error: cannot proceed without suitable wxWidgets library
The kFreeBSD autobuilders still appear to be out of commission (or at
best heavily backlogged), but it looks like they'd run into the same
errors if they were to attempt to build lamarc.
In general, I expect the Linux/FreeBSD settings should make a much
more reasonable default for platforms the build system doesn't
specifically recognize than the settings for macOS, which is not so
mainstream.
Could you please take a look?
Thanks!
--
Aaron M. Ucko, KB1CJC (amu at alum.mit.edu, ucko at debian.org)
http://www.mit.edu/~amu/ | http://stuff.mit.edu/cgi/finger/?a...@monk.mit.edu
