Package: firmware-atheros
Version: 0.43
The ar3k/AthrBT_0x31010000.dfu patch seemingly does not load and as a
result bluetooth is not available using this driver. The message
[ 28.834522] usb 3-7: firmware: failed to load ar3k/AthrBT_0x31010000.dfu (-2)
[ 28.834523] usb 3-7: Direct firmware load failed with error -2
shows during boot then no bluetooth hardware is found by Gnome 3 or Cinnamon.
Kernel log:
Dec 8 15:06:20 debian kernel: [ 28.572735] ath: phy0: WB335 2-ANT
card detected
Dec 8 15:06:20 debian kernel: [ 28.572738] ath: phy0: Set BT/WLAN
RX diversity capability
Dec 8 15:06:20 debian kernel: [ 28.579818] ath: phy0: Enable LNA combining
Dec 8 15:06:20 debian kernel: [ 28.580982] ath: phy0: ASPM enabled: 0x42
Dec 8 15:06:20 debian kernel: [ 28.580983] ath: EEPROM regdomain: 0x65
Dec 8 15:06:20 debian kernel: [ 28.580984] ath: EEPROM indicates we
should expect a direct regpair map
Dec 8 15:06:20 debian kernel: [ 28.580985] ath: Country alpha2 being used: 00
Dec 8 15:06:20 debian kernel: [ 28.580986] ath: Regpair used: 0x65
Dec 8 15:06:20 debian kernel: [ 28.592297] Bluetooth: Core ver 2.19
Dec 8 15:06:20 debian kernel: [ 28.592308] NET: Registered protocol family 31
Dec 8 15:06:20 debian kernel: [ 28.592309] Bluetooth: HCI device
and connection manager initialized
Dec 8 15:06:20 debian kernel: [ 28.592315] Bluetooth: HCI socket
layer initialized
Dec 8 15:06:20 debian kernel: [ 28.592317] Bluetooth: L2CAP socket
layer initialized
Dec 8 15:06:20 debian kernel: [ 28.592323] Bluetooth: SCO socket
layer initialized
Dec 8 15:06:20 debian kernel: [ 28.602165] ieee80211 phy0: Selected
rate control algorithm 'minstrel_ht'
Dec 8 15:06:20 debian kernel: [ 28.602342] ieee80211 phy0: Atheros
AR9565 Rev:1 mem=0xffffc90010f80000, irq=17
Dec 8 15:06:20 debian kernel: [ 28.671334] Adding 13672444k swap on
/dev/mapper/volumes-swap. Priority:-1 extents:1 across:13672444k FS
Dec 8 15:06:20 debian kernel: [ 28.785125] fbcon: inteldrmfb (fb0)
is primary device
Dec 8 15:06:20 debian kernel: [ 28.803812] usbcore: registered new
interface driver btusb
Dec 8 15:06:20 debian kernel: [ 28.834522] usb 3-7: firmware:
failed to load ar3k/AthrBT_0x31010000.dfu (-2)
Dec 8 15:06:20 debian kernel: [ 28.834523] usb 3-7: Direct firmware
load failed with error -2
Dec 8 15:06:20 debian kernel: [ 28.834524] usb 3-7: Falling back to
user helper
Dec 8 15:06:20 debian kernel: [ 28.834878] Bluetooth: Loading patch
file failed
Dec 8 15:06:20 debian kernel: [ 28.834881] ath3k: probe of 3-7:1.0
failed with error -12
System Info:
Linux debian 3.16.0-4-amd64 #1 SMP Debian 3.16.7-ckt2-1 (2014-12-08) x86_64
GNU/Linux
Debian/testing up to date
Hopefully relevant hw info:
*-usbhost:0
product: xHCI Host Controller
vendor: Linux 3.16.0-4-amd64 xhci_hcd
physical id: 0
bus info: usb@4
logical name: usb4
version: 3.16
capabilities: usb-3.00
configuration: driver=hub slots=4 speed=5000Mbit/s
*-usbhost:1
product: xHCI Host Controller
vendor: Linux 3.16.0-4-amd64 xhci_hcd
physical id: 1
bus info: usb@3
logical name: usb3
version: 3.16
capabilities: usb-2.00
configuration: driver=hub slots=14 speed=480Mbit/s
*-usb:0
description: Video
product: Lenovo EasyCamera
vendor: CF0D9SMDX
physical id: 4
bus info: usb@3:4
version: 0.09
serial: 200901010001
capabilities: usb-2.00
configuration: driver=uvcvideo maxpower=500mA
speed=480Mbit/s
*-usb:1 UNCLAIMED
description: Bluetooth wireless interface
vendor: Atheros Communications, Inc.
physical id: 7
bus info: usb@3:7
version: 0.01
capabilities: bluetooth usb-1.10
configuration: maxpower=100mA speed=12Mbit/s
*-usb:2
description: Generic USB device
product: USB2.0-CRW
vendor: Generic
physical id: 8
bus info: usb@3:8
version: 39.60
serial: 20100201396000000
capabilities: usb-2.00
configuration: driver=rtsx_usb maxpower=500mA
speed=480Mbit/s
