On Mon, Jun 11, 2012 at 10:26:06AM -0700, Kenyon Ralph wrote: > On 2012-06-11T15:00:24+0200, SamLT <sam-d...@sltosis.org> wrote: > > Same idea, but I leave here the default file untouched, and find the > > IPv4/IPv6 addresses from the tayga config(ipv4-addr/ipv6-addr), as for > > the other parameters(prefix, dynamic-pool...). > > I believe your patch is not correct because the nat64 TUN device > should have addresses from different networks than what TAYGA is > using. The ipv4-addr and ipv6-addr (or the address TAYGA generates > using ipv4-addr and the IPv6 NAT64 prefix) in /etc/tayga.conf are used > internally by TAYGA and will not be visible in 'ip address show' > output. So you need to create new configuration variables outside of > tayga.conf, which is why I added variables to /etc/default/tayga. >
You're right, now that I read the doc again, I don't now what I was thinking! So for the maintainer, forget my patch, but probably keep the comment about the $TUN_DEVICE variable in mind. Thanks for your comment Kenyon Ralph. sam -- To UNSUBSCRIBE, email to debian-bugs-dist-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org
