Package: installation-reports Boot method: CD Image version: http://cdimage.debian.org/cdimage/daily-builds/daily/20080410-2/i386/iso-cd/debian-testing-i386-netinst.iso Date: Apr 11 2008 01:00 UTC
Machine: Pc clon Processor: PIV 2.4 ghz Memory: 1 gb Partitions: /dev/sda1 jfs mounted as / /dev/sda3 xfs mouned as /home /dev/sda5 swap /dev/sda6 xfs mounted as /data Output of lspci -nn and lspci -vnn: ( I'll send it to you later ) I've two disk drives : - 80 gb serial ata ( initially detected as /dev/sda and after installation /dev/sdb ) - 40 gb ata-133 ( initially detected as /dev/hdc and after installation /dev/sda ) Base System Installation Checklist: [O] Initial boot: [O] Detect network card: [O] Configure network: [O] Detect CD: [O] Load installer modules: [O] Detect hard drives: [O] Partition hard drives: [O] Install base system: [O] Clock/timezone setup: [O] User/password setup: [O] Install tasks: [O] Install boot loader: [O] Overall install: [O] Comments/Problems: The problem is that after rebootig, grub boots ok, but then when it tries to start the system, it can't find the partition /dev/sda1 ( as it was detected at installation time ). What I found out was that the disk was now detected as /dev/sdb instead of /dev/sda. So I changed the parameter in grub ( "E" command ) and changed /dev/sda1 by /dev/sdb1. After that, it loads the kernel but the system can't find the other partitions ( /dev/sda3 /dev/sda5 - swap - /dev/sda6 ). At that moment, it is proposed to give root password for entering in maintenance mode, so I did it. Then I changed the contents of the /dev/fstab to match the new way the disk is detected ( /dev/sdb instead of /dev/sda ). I alsa have to change the configuration file of the resume to point to the "new" swap partition. After that the system works great. Regards. Facundo. Buenos Aires - Argentina -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
