When installing rev4, there is a section that reads roughly
Special boot parameters
You can use the following parameters....
This list is incomplete, see the kernel's kernels-parameters.txt file.
Where is this file located?
Ultimately, I'd like to use the nforce4 software raid on my gigabyte
GA-k8n ultra-9. However, if that is not possible, I'd like to see what
raid controllers are supported.
Just as an FYI, I have Suse 10.2 installed and it recognizes the
software raid. Since both distributions are using the same kernel, I
would expect Debian to have the same feature.
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
