Package: installation-reports
Version: 20070510-09:08
Boot method: CD
Image version:
http://cdimage.debian.org/cdimage/daily-builds/daily/arch-latest/ia64/iso-cd/debian-testing-ia64-netinst.iso
Date: 2007.07.26 14:10 EST
Machine: HP I2000
Processor: Itanium 1, 733MHz
Memory: 4G
Partitions: None
Output of lspci -nn and lspci -vnn:
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot: [E]
Detect network card: [E]
Configure network: [ ]
Detect CD: [ ]
Load installer modules: [ ]
Detect hard drives: [ ]
Partition hard drives: [ ]
Install base system: [ ]
Clock/timezone setup: [ ]
User/password setup: [ ]
Install tasks: [ ]
Install boot loader: [ ]
Overall install: [ ]
Comments/Problems:
The EFI filesystem wasn't recognised by the firmware
bootloader, so I had to boot from the EFI shell.
The first few steps worked, until it came time to configure the
network. It appears there are no network driver modules on the CD.
This machine has an E100 Pro, and a DP83820. Neither driver was
present, so I could not complete the installation.
The disk version is: Debian GNU/Linux testing "Lenny" - Official
Snapshot ia64 NETINST Binary-1 20070510-09:08
I also tried the `business card' image with the same result.
--
Dr Peter Chubb http://www.gelato.unsw.edu.au peterc AT gelato.unsw.edu.au
http://www.ertos.nicta.com.au ERTOS within National ICT Australia
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
