Package: installation-reports
Boot method: CD
Image version:
http://cdimage.debian.org/cdimage/weekly-builds/i386/jigdo-cd/debian-testing-i386-CD-1.template
Date: 19 May 2007
Machine: Dell Dimension XPS T450
Processor: PIII 450MHz
Memory: 512MB
Partitions: N/A
Output of lspci -nn and lspci -vnn:
0000:00:00.0 0600: 8086:7190 (rev 03)
Flags: bus master, medium devsel, latency 64
Memory at f8000000 (32-bit, prefetchable) [size=64M]
Capabilities: [a0] AGP version 1.0
0000:00:01.0 0604: 8086:7191 (rev 03)
Flags: bus master, 66MHz, medium devsel, latency 128
Bus: primary=00, secondary=01, subordinate=01, sec-latency=64
I/O behind bridge: 00009000-00009fff
Memory behind bridge: f4100000-f5ffffff
0000:00:07.0 0601: 8086:7110 (rev 02)
Flags: bus master, medium devsel, latency 0
0000:00:07.1 0101: 8086:7111 (rev 01) (prog-if 80 [Master])
Flags: bus master, medium devsel, latency 64
I/O ports at 10a0 [size=16]
0000:00:07.2 0c03: 8086:7112 (rev 01)
Flags: bus master, medium devsel, latency 64, IRQ 9
I/O ports at 1080 [size=32]
0000:00:07.3 0680: 8086:7113 (rev 02)
Flags: medium devsel, IRQ 9
0000:00:0d.0 0200: 10b7:9200 (rev 6c)
Subsystem: 10b7:1000
Flags: bus master, medium devsel, latency 80, IRQ 11
I/O ports at 1000 [size=128]
Memory at f4000000 (32-bit, non-prefetchable) [size=128]
Expansion ROM at <unassigned> [disabled] [size=128K]
Capabilities: [dc] Power Management version 2
0000:01:00.0 0300: 1002:4742 (rev 5c)
Subsystem: 1002:0084
Flags: bus master, stepping, medium devsel, latency 66
Memory at f5000000 (32-bit, non-prefetchable) [size=16M]
I/O ports at 9000 [size=256]
Memory at f4100000 (32-bit, non-prefetchable) [size=4K]
Expansion ROM at <unassigned> [disabled] [size=128K]
Capabilities: [50] AGP version 1.0
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot: [O]
Detect network card: [O]
Configure network: [O]
Detect CD: [O]
Load installer modules: [O]
Detect hard drives: [E]
Partition hard drives: [ ]
Install base system: [ ]
Clock/timezone setup: [ ]
User/password setup: [ ]
Install tasks: [ ]
Install boot loader: [ ]
Overall install: [ ]
Comments/Problems:
Everything went fine until it tried to detect the hard drives. It could
not find my installed hard drive. The hard drive shows up on the BIOS
and in /sys/block/hda after the install disk is booted. The drive is
installed as the master on the ide0 controller. The CD is the master
on ide1.
I was able to boot up in an older version of Knoppix (with a 2.4 kernel)
and partition, format, and mount the drive. I was able to partition the
disk and write to it using dd from the Debian installer command line, but
I could not format it. When I tried to format the disk from the installer
command line, I got a floating point exception.
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
