Iīve tried to rectify this problem, but realised I need some further guidance...
I can not find the information I need; when the system boot, the screen fills to fast to read and then, when it hangs, the information Iīm looking for is gone above the visible screen. Also, going to /target/var/log there is no kern.log. The logs that are available are: auth.log btmp debian-installer exim4 ksymoops lastlog news syslog wtmp. I couldnīt find any relevant information from any of these. Any suggestions? Thank you, Johan --- Frans Pop <[EMAIL PROTECTED]> skrev: > On Sunday 02 January 2005 21:27, Johan Ebbinghaus > wrote: > > Comments/Problems: > > During reboot the system hangs. This is what can > be > > seen on the screen when the boot hangs: > > ------------------------------------------- > > /etc/rcS.d/S38discover: line 204: 389 segmentation > > fault modprobe $MODULE > > usb-uhci disabled in configuration > > Loading ehci-hcd module. > > <6>usb.c: registered new driver usbdevfs > > usb.c: registered new driver hub > > ------------------------------------------- > > Just before this point, there should be a line > listing which module was > going to be installed. > Before that, there should also be a line enumerating > the modules that > discover is going to try to install (and the > sequence in which it will do > this). > From that you may be able to determine which module > is causing the > problems. > > Next step is to blacklist these modules in > /etc/discover/... > See our FAQ [1] - question 28 - for instructions on > how to use the > installer for this. (You can also check > /target/var/log/kern.log for any > messages from the failed boot while you're at it.) > > Note: you may also have to blacklist the same module > for hotplug. > > Please let us know the results so we can reassign > this report to the > kernel. > > [1] > http://wiki.debian.net/index.cgi?DebianInstallerFAQ > > Cheers, > FJP > > -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
