Package: installation-reports Debian-installer-version: 7/12/2004 from http://cdimage.debian.org/pub/cdimage-testing/sarge_d-i/i386/rc2/sarge-i 386-netinst.iso uname -a: Linux cvsserver 2.4.27-1-386 #1 Fri Sep 3 06:24:46 UTC 2004 i686 GNU/Linux Date: 7/12/2004 18:20 Method: using a image for the installation from the net; no proxy, only a firewall
Machine: M Mitas Processor: Pentium IV Memory: 512 MB Root Device: <IDE Quantum...> Root Size/partition table: <38 GB of ext3 1.6GB of swap> Disk /dev/hda: 61.4 GB, 61492838400 bytes 255 heads, 63 sectors/track, 7476 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes Device Boot Start End Blocks Id System /dev/hda1 * 1 7475 60042906 44 Unknown Disk /dev/hdb: 40.0 GB, 40027029504 bytes 255 heads, 63 sectors/track, 4866 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes Device Boot Start End Blocks Id System /dev/hdb1 * 1 4673 37535841 83 Linux /dev/hdb2 4674 4866 1550272+ f W95 Ext'd (LBA) /dev/hdb5 4674 4866 1550241 82 Linux swap Output of lspci and lspci -n: 0000:00:00.0 Host bridge: Intel Corp. 82845G/GL[Brookdale-G]/GE/PE DRAM Controller/Host-Hub Interface (rev 02) 0000:00:01.0 PCI bridge: Intel Corp. 82845G/GL[Brookdale-G]/GE/PE Host-to-AGP Bridge (rev 02) 0000:00:1d.0 USB Controller: Intel Corp. 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) USB UHCI Controller #1 (rev 02) 0000:00:1d.1 USB Controller: Intel Corp. 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) USB UHCI Controller #2 (rev 02) 0000:00:1d.2 USB Controller: Intel Corp. 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) USB UHCI Controller #3 (rev 02) 0000:00:1d.7 USB Controller: Intel Corp. 82801DB/DBM (ICH4/ICH4-M) USB 2.0 EHCI Controller (rev 02) 0000:00:1e.0 PCI bridge: Intel Corp. 82801 PCI Bridge (rev 82) 0000:00:1f.0 ISA bridge: Intel Corp. 82801DB/DBL (ICH4/ICH4-L) LPC Bridge (rev 02) 0000:00:1f.1 IDE interface: Intel Corp. 82801DB/DBL (ICH4/ICH4-L) UltraATA-100 IDE Controller (rev 02) 0000:00:1f.3 SMBus: Intel Corp. 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) SMBus Controller (rev 02) 0000:00:1f.5 Multimedia audio controller: Intel Corp. 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) AC'97 Audio Controller (rev 02) 0000:01:00.0 VGA compatible controller: nVidia Corporation NV18 [GeForce4 MX 440 AGP 8x] (rev a2) 0000:02:05.0 Ethernet controller: Broadcom Corporation BCM4401 100Base-T (rev 01) 0000:00:00.0 0600: 8086:2560 (rev 02) 0000:00:01.0 0604: 8086:2561 (rev 02) 0000:00:1d.0 0c03: 8086:24c2 (rev 02) 0000:00:1d.1 0c03: 8086:24c4 (rev 02) 0000:00:1d.2 0c03: 8086:24c7 (rev 02) 0000:00:1d.7 0c03: 8086:24cd (rev 02) 0000:00:1e.0 0604: 8086:244e (rev 82) 0000:00:1f.0 0601: 8086:24c0 (rev 02) 0000:00:1f.1 0101: 8086:24cb (rev 02) 0000:00:1f.3 0c05: 8086:24c3 (rev 02) 0000:00:1f.5 0401: 8086:24c5 (rev 02) 0000:01:00.0 0300: 10de:0181 (rev a2) 0000:02:05.0 0200: 14e4:4401 (rev 01) Base System Installation Checklist: [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Initial boot worked: [O] Configure network HW: [O] Config network: [O] Detect CD: [O] Load installer modules: [O] Detect hard drives: [O] Partition hard drives: [O] Create file systems: [O] Mount partitions: [O] Install base system: [O] Install boot loader: [O] Reboot: [O] Comments/Problems: The boot loader has made some problem on the other disk to pre-existent Windows XP (which cannot boot anymore). The Windows XP says: autocheck program not found: skipping AUTOCHK then, the system reboots. No solutions were found in at: http://wiki.debian.net/DebianInstallerFAQ : Issue n. 1 is ok Issue n. 2 is too vague: there is a correct configuration of GRUB, and no 2.6 kernel has been installed. Patrick Zanon, Dr., Ing. Isolcell Italia Spa Electronic Department Via Meucci, 7 [EMAIL PROTECTED] 39055 - Laives (BZ) ITALY Tel: +39.0471.954050 Web: www.isolcell.it Fax: +39.0471.953575 E-mail: [EMAIL PROTECTED] ------------------------------------------------------------------------ --- Disclaimer This E-mail is intended only for the address(es) explicitly indicated in the header; thus, it may not be transmitted, nor made available for use, by any other person which is not included in the recipient list. If you receive this message in error, please delete its content, and inform us immediately. Thanks.
