Package: installation-reports Debian-installer-version: <2004/09/15 www.debian.org> uname -a: <Couldn't install> Date: <Couldn't install> Method: <Couldn't install>
Machine: <Dell Dimension 8100> Processor:P4 Memory:640MB RDRAM Root Device: <IDE Promise TX2000> Root Size/partition table: <Unable to set up root partition> Output of lspci and lspci -n: Base System Installation Checklist: [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Initial boot worked: [O] Configure network HW: [O] Config network: [O] Detect CD: [O] Load installer modules: [O] Detect hard drives: [O] Partition hard drives: [O] Create file systems: [E] Mount partitions: [ ] Install base system: [ ] Install boot loader: [ ] Reboot: [ ] Comments/Problems: I have Promise TX2000 card and 2xWD120GB drives, was hoping to install a RAID1 array. Install did not recognise raid hardware. Instead recognised as two seperate ide drives. So I go with a software array. Partition both dirves as raid drives. Built Multi Disk array. Partition RAID using partition guide. Everythig OK until it finishes partitioning and then it gives a bland error message about unable to partition and dumps me back in the partitioning tool. No meaningful messages. ===== +-----------------------------------------------+ | /\ |\/| | | /--\LISTAIR | |OIR. [EMAIL PROTECTED] | +-----------------------------------------------+ -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
