Package: installation-reports Debian-installer-version: October-8-2004, Debian-Installer Pre-rc2 uname -a: Linux venus 2.4.27-1-k7 #1 Fri Sep 3 06:21:29 UTC 2004 i686 GNU/LinuxDate: October-8-2004, 11:00PM (Taiwan time) Method: netinst CD i386, deb ftp://debian.csie.ntu.edu.tw/pub/debian/ testing main deb-src ftp://debian.csie.ntu.edu.tw/pub/debian/ testing main From Taipei, Taiwan. Not proxied.
Machine: I built this computer. Asus A7A266 Mother board with ALI M1535D+ A1 0112 TH07 chipset.Processor: AMD, 1.2 Ghz Athlon. Memory: 128MB (Samsung), tested for errors with memtest. Root Device: IDE, device hdb. Root Size/partition table: Nothing special ... Disk /dev/hdb: 10.2 GB, 10262568960 bytes 255 heads, 63 sectors/track, 1247 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes Device Boot Start End Blocks Id System /dev/hdb1 * 1 349 2803311 83 Linux /dev/hdb2 350 1247 7213185 5 Extended /dev/hdb5 350 393 353398+ 82 Linux swap /dev/hdb6 394 1247 6859723+ 83 Linux Output of lspci and lspci -n: lspci output: 0000:00:00.0 Host bridge: ALi Corporation M1647 Northbridge [MAGiK 1 / MobileMAGiK 1] (rev 04)0000:00:01.0 PCI bridge: ALi Corporation PCI to AGP Controller 0000:00:02.0 USB Controller: ALi Corporation USB 1.1 Controller (rev 03) 0000:00:04.0 IDE interface: ALi Corporation M5229 IDE (rev c4) 0000:00:05.0 Multimedia audio controller: C-Media Electronics Inc CM8738 (rev 10)0000:00:06.0 USB Controller: ALi Corporation USB 1.1 Controller (rev 03) 0000:00:07.0 ISA bridge: ALi Corporation M1533 PCI to ISA Bridge [Aladdin IV] 0000:00:0a.0 Ethernet controller: Lite-On Communications Inc LNE100TX (rev 20)0000:00:11.0 Bridge: ALi Corporation M7101 Power Management Controller [PMU] 0000:01:00.0 VGA compatible controller: ATI Technologies Inc Radeon R100 QD [Radeon 7200] lspci -n output: 0000:00:00.0 0600: 10b9:1647 (rev 04) 0000:00:01.0 0604: 10b9:5247 0000:00:02.0 0c03: 10b9:5237 (rev 03) 0000:00:04.0 0101: 10b9:5229 (rev c4) 0000:00:05.0 0401: 13f6:0111 (rev 10) 0000:00:06.0 0c03: 10b9:5237 (rev 03) 0000:00:07.0 0601: 10b9:1533 0000:00:0a.0 0200: 11ad:0002 (rev 20) 0000:00:11.0 0680: 10b9:7101 0000:01:00.0 0300: 1002:5144 Base System Installation Checklist: [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Initial boot worked: [O] Configure network HW: [O] Config network: [O] Detect CD: [O] Load installer modules: [O] Detect hard drives: [O] Partition hard drives: [O] Create file systems: [O] Mount partitions: [O] Install base system: [O] Install boot loader: [O] Reboot: [O] Comments/Problems: First I want to say that the install went very well overall! Thanks for your hard work. The message "i8253 count to high! resetting.." is printed to the screen on top of configuration screen. It happened 2 or 3 times, and then later durring normal system boot. It wasn't clear to me what caused it. It appeared to show up randomly. dmesg returns healthy messages except the following: <snipet> eth0: Setting full-duplex based on MII#1 link partner capability of 45e1. apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16) [drm] Initialized radeon 1.7.0 20020828 on minor 0 [drm:radeon_unlock] *ERROR* Process 1156 using kernel context 0 inserting floppy driver for 2.4.27-1-k7 Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 spurious 8259A interrupt: IRQ7. i8253 count too high! resetting.. i8253 count too high! resetting.. i8253 count too high! resetting.. </snipet> "i8253 count too high! resetting.." continues to repeat for a few pages. Also, Despite setting the monitor resolution to 1024x760 @ 75Mhz durring the installation configuration, when I log in, it appears to be set to 800x600 @ 75Mhz. The Gnome "Screen Resolution Preferences" window does not allow me to set my screen resolution to 1024x760 @ 75Mhz. I can only choose between 800x768 and 640x480. Hope this helps.
