Package: installation-reports INSTALL REPORT
Debian-installer-version: http://cdimage.debian.org/pub/cdimage-testing/daily/sparc/20040830/sarge-sparc-netinst.iso uname -a: Linux ikari.its.monash.edu.au 2.4.26-sparc32 #1 Sun Jun 20 02:18:47 PDT 2004 sparc GNU/Linux Date: Tue, 31 Aug 2004 03:53:00 +0000 Method: cdrom Machine: Sun4m SparcStation 20 Processor: CPU 0 <node=ffd6f150,mid=8> 74.75 BogoMIPS Memory: 216348k Root Device: SCSI device sdb /dev/sdb1 SCSI subsystem driver Revision: 1.00 esp0: IRQ 36 SCSI ID 7 Clk 40MHz CCYC=25000 CCF=8 TOut 167 NCR53C9XF(espfast) ESP: Total of 1 ESP hosts found, 1 actually in use. scsi0 : Sparc ESP100A-FAST Vendor: IBM Model: DCAS32160SUN2.1G Rev: S65A Type: Direct-Access ANSI SCSI revision: 02 Vendor: IBM Model: DCAS32160SUN2.1G Rev: S65A Type: Direct-Access ANSI SCSI revision: 02 Vendor: TOSHIBA Model: XM-4101TASUNSLCD Rev: 1755 Type: CD-ROM ANSI SCSI revision: 02 Attached scsi disk sda at scsi0, channel 0, id 1, lun 0 Attached scsi disk sdb at scsi0, channel 0, id 3, lun 0 esp0: target 1 [period 100ns offset 15 10.00MHz FAST SCSI-II] SCSI device sda: 4226725 512-byte hdwr sectors (2164 MB) Partition check: /dev/scsi/host0/bus0/target1/lun0: p1 p3 esp0: target 3 [period 100ns offset 15 10.00MHz FAST SCSI-II] SCSI device sdb: 4226725 512-byte hdwr sectors (2164 MB) /dev/scsi/host0/bus0/target3/lun0: p1 p2 p3 p4 Root Size/partition table: ikari:~# fdisk -l /dev/sda Disk /dev/sda (Sun disk label): 19 heads, 80 sectors, 2733 cylinders Units = cylinders of 1520 * 512 bytes Device Flag Start End Blocks Id System /dev/sda1 0 2733 2077080 83 Linux native /dev/sda3 0 2733 2077080 5 Whole disk ikari:~# fdisk -l /dev/sdb Disk /dev/sdb (Sun disk label): 19 heads, 80 sectors, 2733 cylinders Units = cylinders of 1520 * 512 bytes Device Flag Start End Blocks Id System /dev/sdb1 0 128 97280 1 Boot /dev/sdb2 128 2569 1855160 83 Linux native /dev/sdb3 0 2733 2077080 5 Whole disk /dev/sdb4 2617 2733 88160 82 Linux swap ikari:~# df Filesystem 1K-blocks Used Available Use% Mounted on /dev/sdb2 1738609 154698 1491153 10% / tmpfs 108240 0 108240 0% /dev/shm /dev/sdb1 91159 5670 80625 7% /boot /dev/sda1 1946669 8244 1834571 1% /home Output of lspci and lspci -n: ikari:~# lspci pcilib: Cannot open /proc/bus/pci lspci: Cannot find any working access method. Base System Installation Checklist: [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Initial boot worked: [O] Configure network HW: [O] Config network: [O] Detect CD: [O] Load installer modules: [O] Detect hard drives: [O] Partition hard drives: [O] Create file systems: [O] Mount partitions: [O] Install base system: [O] Install boot loader: [O] Reboot: [O] However, I have to do 'boot disk'. See below. Comments/Problems: 1.After the reboot, it displayed "Illegal Instruction". It displayed the same message after doing 'boot'. I had to do 'boot disk' to finish the install. Please stand by while rebooting the system. Restarting system. .esetting ... SPARCstation 20 (1 X SuperSPARC-II), No Keyboard ROM Rev. 2.22, 224 MB memory installed, Serial #7702854. Ethernet address 8:0:20:75:89:46, Host ID: 72758946. Boot device: /iommu/sbus/[EMAIL PROTECTED],400000/[EMAIL PROTECTED],800000/[EMAIL PROTECTED],0:a File and args: Illegal Instruction Type help for more information ok ok boot .esetting ... SPARCstation 20 (1 X SuperSPARC-II), No Keyboard ROM Rev. 2.22, 224 MB memory installed, Serial #7702854. Ethernet address 8:0:20:75:89:46, Host ID: 72758946. Rebooting with command: Boot device: /iommu/sbus/[EMAIL PROTECTED],400000/[EMAIL PROTECTED],800000/[EMAIL PROTECTED],0:a File and args: Illegal Instruction Type help for more information ok boot disk 2.Block cursor was invisible when asked if time was GMT. It was visible again when prompted for the the apt sources list information. Anibal Monsalve Salazar -- .''`. Debian GNU/Linux | Building 28C : :' : Free Operating System | Monash University VIC 3800 Australia `. `' http://debian.org/ | http://www-personal.monash.edu/~anibal `-
signature.asc
Description: Digital signature
