Package: installation-reports Debian-installer-version: rc1 http://cdimage.debian.org/pub/cdimage-testing/sarge_d-i/powerpc/rc1/sarge-powerpc-netinst.iso uname -a: Date: 09.08.2004 Method: BootX from mac os with 2.4 kernel and initrd Machine: Umax S900 Processor: 604e Memory: 465 Root Device: scsi internal mac mesh Root Size/partition table: /dev/sda1 Apple_partition_map Apple 63 @ 1 ( 31.5k) Partition map /dev/sda2 Apple_Bootstrap untitled 7978516 @ 64 ( 3.8G) NewWorld bootblock /dev/sda3 Apple_UNIX_SVR2 swap 420076 @ 7978580 (205.1M) Linux swap Output of lspci: 0000:00:0b.0 Host bridge: Apple Computer Inc. Bandit PowerPC host bridge(rev03) 0000:00:0d.0 VGA compatible controller: 3Dfx Interactive, Inc. Voodoo 3(rev01) 0000:00:0e.0 SCSI storage controller: Adaptec AHA-2940U/UW/D / AIC-7881U 0000:00:0f.0 PCI bridge: Digital Equipment Corporation DECchip 21052 (rev 02) 0000:00:10.0 ff00: Apple Computer Inc. Grand Central I/O (rev 02) 0000:01:01.0 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 50) 0000:01:01.1 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 50) 0000:01:01.2 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 51) Base System Installation Checklist:
Initial boot worked: [O] Configure network HW: [O] Config network: [O] Detect CD: [O] Load installer modules: [O] Detect hard drives: [O] Partition hard drives: [O] Create file systems: [O] Mount partitions: [O] Install base system: [O] Install boot loader: [E] Reboot: [E] I could not install boot loader, because formated my drive with ext3 and quik doesnt support it. Should be a warning earlier in install process to use ext2 with quik. Comments/Problems: After the step to install without boot loader the system should ask to reboot and not do it automatic. Chrooted later from other system installed quik on ext3 and created quik.conf. Updated my openfirmware settings with nvsetenv to boot from scsi-int. Then booted into new debian sarge all configs went okay. -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
