Package: installation-reports Debian-installer-version: sarge_d-i/i386/20040806/sarge-i386-netinst.iso uname -a: Linux weasel 2.6.7 #1 Fri Aug 6 23:58:04 EST 2004 i686 GNU/Linux Date: Fri Aug 6 13:00 2004 Method: netinst cd, booted from cd, used 2.6 kernel. Additional packages installed via apt-proxy from internal lan (apt-proxy points mainly at mirror.aarnet.edu.au). Machine: Generic x86, Gigabyte 7VM400M-RZ motherboard, Northbridge VIA KM400, Southbridge VIA 8235, On-Board VIA VT6103 (via-rhine) Lan. Processor: Athlon XP 1800 Memory: 256mb Root Device: IDE (On-Board VIA), ATA 133, Maxtor 40g hdd Root Size/partition table: Disk /dev/hda: 41.1 GB, 41110142976 bytes 255 heads, 63 sectors/track, 4998 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System /dev/hda1 * 1 2492 20016958+ 83 Linux /dev/hda2 4936 4998 506047+ 82 Linux swap /dev/hda3 2493 4935 19623397+ a6 OpenBSD Output of lspci: 0000:00:00.0 Host bridge: VIA Technologies, Inc. VT8378 [KM400] Chipset Host Bridge 0000:00:01.0 PCI bridge: VIA Technologies, Inc. VT8237 PCI Bridge 0000:00:0b.0 Ethernet controller: Digital Equipment Corporation DECchip 21041 [Tulip Pass 3] (rev 21) 0000:00:10.0 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 80) 0000:00:10.1 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 80) 0000:00:10.2 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 80) 0000:00:10.3 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 82) 0000:00:11.0 ISA bridge: VIA Technologies, Inc. VT8235 ISA Bridge 0000:00:11.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06) 0000:00:12.0 Ethernet controller: VIA Technologies, Inc. VT6102 [Rhine-II] (rev 74) 0000:01:00.0 VGA compatible controller: VIA Technologies, Inc. VT8378 [S3 UniChrome] Integrated Video (rev 01) Base System Installation Checklist: Initial boot worked: [O] Configure network HW: [O] Config network: [O] Detect CD: [O] Load installer modules: [O] Detect hard drives: [O] Partition hard drives: [O] Create file systems: [O] Mount partitions: [O] Install base system: [O] Install boot loader: [O] Reboot: [O] [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Comments/Problems: One of the most straight forward installers I have ever used, well done!! -- Stephen M. Gava <[EMAIL PROTECTED]> -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
