Package: installation-reports
Debian-installer-version: 2004/07/20 http://cdimage.debian.org/pub/cdimage-testing/sarge_d-i/i386/20040720/sarge-i386-netinst.iso
uname -a: 2.6...
Date: 2004/07/21
Method: Boot-CD (try to install on SATA hard disk)
Machine: Shuttle SN85G4V2 - Mainboard: FN85 (nVidia nForce 3 150)
Processor: Athlon64 3200+ (CG-Steping(AR))
Memory: 1024 MB
Root Device: Samsung Spinpoint SATA harddrive on a Silicon Image SiI 3512 Controller
Root Size/artition table: in this order: 1. two NTFS partitions, 2. one FAT32 partition, 3. three ext3 partitions 4. swap partition
Output of lspci: ?
Base System Installation Checklist:
Initial boot worked: [O] Configure network HW: [O] Config network: [O] Detect CD: [O] Load installer modules: [O] Detect hard drives: [E] Partition hard drives: [E] Create file systems: [E] Mount partitions: [ ] Install base system: [ ] Install boot loader: [ ] Reboot: [ ] [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Comments/Problems:
The Silicon Image SiI 3512 wasn't detected by the installer. But after a 'modprobe sata_sil' the hard disk detection works.
But random crashes occur by hard disk access. So, formatting some partitions causes a system hang-up.
(Note: The sata_sil driver on the gentoo live CD 2004.1-amd64 works fine for me!)
Another issue: Menus of the d-i displayed disturbed. I think, I've tested a unlucky daily build.
-- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
