On Thu, Jun 03, 2004 at 11:52:58PM +0200, Thorsten Schaefer wrote: > I've done about six further installations. Everytime the Xircom PCMCIA > network card (REM56G-100) is used, the network card worked during the > initial installation process, didn't work after the first reboot (so during > the installation part that follows) and after all following reboots works. > To verify if it is possible to get the network running after the first > reboot I've run an /etc/init.d/networking restart (and also tried with stop > and start) but the command didn't succeed. The message "Reconfiguring > network interfaces" is displayed. Also an "init 1" and then "init 3" didn't > make a difference.
I've got an RBEM56G-100, which I assume is similar. I've discovered that it doesn't work if the "xircom_tulip_cb" module is loaded, but does work if only the "xircom_cb" module is loaded. Could you please run "lsmod | grep xircom" to check which one it's using? Perhaps discover is choosing the wrong module. -- Nicholas Breen [EMAIL PROTECTED] -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
