On Sun, 30 May 2004, Joshua Kwan wrote: > Folks, > > Here is a mini-ISO image I cooked up with SILO rolled back to 1.3.2. Tom > Callaway suggested that I try this because a lot of new stuff related to > initrds changed in 1.4.x. > > http://june.voxel.net/~joshk/mini.iso > > Tell us what happens! (And wish me luck on finals!) > > -- > Joshua Kwan
Hi, I have tested the installation with the above image on Sparcstation 10 using the serial console. The image works fine except for a couple of minor quirks, which do not seem to affect overall functionality (was able to complete the install just fine): 1. After the initial boot it tries to load modules sunhme (which seems to be wrong for my hardware - Sparcstation 10) and sr_mod (which is not included). Following messages appear in /var/log/messages: Using /lib/modules/2.4.26-sparc32/kernel/drivers/net/sunhme.o insmod: init_module: sunhme: No such device insmod sunhme modprobe: failed to load module sunhme insmod: sr_mod.o: no module by that name found insmod sr_mod modprobe: failed to load module sr_mod 2. After the installer components are downloaded, attempt to load sunhme module is done again and, again, it fails. 3. The pseudographics is screwed up after reboot as reported before and as shown at http://www.wooyd.org/d-i/second.png Best regards and good luck with exams, Jurij Smakov [EMAIL PROTECTED] Key: http://www.wooyd.org/pgpkey/ KeyID: C99E03CC -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
