Package: installation-reports INSTALL REPORT
Debian-installer-version: http://cdimage.debian.org/pub/cdimage-testing/daily/i386/20040515/sarge-i386-businesscard.iso uname -a: Linux luuptup 2.6.5-1-k7 #2 Fri Apr 30 20:46:35 EST 2004 i686 GNU/Linux Date: So Mai 16 15:58:14 CEST 2004 Method: How did you install? What did you boot off? If network install, from where? Proxied? install over wlan pcmcia card, no proxy, ftp.de.debian.org Machine: Sony PCG-FX505(Laptop) Processor: AMD Athlon 1,2 GHz Memory: 256MB Root Device: ide0 Root Size/partition table: 3 0 29302560 hda 3 1 15235384 hda1 (ext3) 3 2 1 hda2 3 5 13550796 hda5 (ntfs) 3 6 499905 hda6 (swap) Output of lspci and lspci -n: lspci 0000:00:00.0 Host bridge: VIA Technologies, Inc. VT8363/8365 [KT133/KM133] (rev 03) 0000:00:01.0 PCI bridge: VIA Technologies, Inc. VT8363/8365 [KT133/KM133 AGP] 0000:00:07.0 ISA bridge: VIA Technologies, Inc. VT82C686 [Apollo Super South] (rev 40) 0000:00:07.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06) 0000:00:07.2 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 1a) 0000:00:07.3 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 1a) 0000:00:07.4 ISA bridge: VIA Technologies, Inc. VT82C686 [Apollo Super ACPI] (rev 40) 0000:00:07.5 Multimedia audio controller: VIA Technologies, Inc. VT82C686 AC97 Audio Controller (rev 50) 0000:00:07.6 Communication controller: VIA Technologies, Inc. Intel 537 [AC97 Modem] (rev 30) 0000:00:0a.0 CardBus bridge: Texas Instruments PCI1420 0000:00:0a.1 CardBus bridge: Texas Instruments PCI1420 0000:00:0e.0 FireWire (IEEE 1394): Texas Instruments TSB12LV26 IEEE-1394 Controller (Link) 0000:00:10.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10) 0000:01:00.0 VGA compatible controller: ATI Technologies Inc Rage Mobility P/M AGP 2x (rev 64) lspci -n 0000:00:00.0 Class 0600: 1106:0305 (rev 03) 0000:00:01.0 Class 0604: 1106:8305 0000:00:07.0 Class 0601: 1106:0686 (rev 40) 0000:00:07.1 Class 0101: 1106:0571 (rev 06) 0000:00:07.2 Class 0c03: 1106:3038 (rev 1a) 0000:00:07.3 Class 0c03: 1106:3038 (rev 1a) 0000:00:07.4 Class 0601: 1106:3057 (rev 40) 0000:00:07.5 Class 0401: 1106:3058 (rev 50) 0000:00:07.6 Class 0780: 1106:3068 (rev 30) 0000:00:0a.0 Class 0607: 104c:ac51 0000:00:0a.1 Class 0607: 104c:ac51 0000:00:0e.0 Class 0c00: 104c:8020 0000:00:10.0 Class 0200: 10ec:8139 (rev 10) 0000:01:00.0 Class 0300: 1002:4c4d (rev 64) Base System Installation Checklist: [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Initial boot worked: [O] Configure network HW: [O] Config network: [E] Detect CD: [O] Load installer modules: [O] Detect hard drives: [O] Partition hard drives: [E] Create file systems: [O] Mount partitions: [O] Install base system: [O] Install boot loader: [O] Reboot: [O] Comments/Problems: netgear wlan card was detected and driver was loaded, i could not see or select the ESSID of the network it connected to, but was only asked for a WEP key. since there is no dhcp on the net, dhcp failed; the installer did not offer me the manual config instead, but tried to access the debian mirror. back in the main menu, typing in the ip address the interface was not configured. switched to the console and configured it by hand. the hard disk had two ntfs paritions, of wich i wanted to delete one and keep the other to copy the data later. this was not able with partman, since it only allows me to delete the howl disk, but not a single partition. i could not find a way to install cfdisk as udeb or another way to partition the disk, so i copied cfdisk from another pc and deleted the ntfs partition. now i was able to use the parman to create new partitions. after rebooting the wlan interface moved from eth1 to eth2 since the firewire interface was found and used as eth1. -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
