Package: installation-reports Debian-installer-version: 2004-Apr-02, http://www.debian.org/devel/debian-installer/ uname -a: Linux arcadia 2.4.21-199-athlon #1 Fri Mar 12 08:24:04 UTC 2004 i686 athlon i386 GNU/Linux Date: 2004-Apr-02 Method: Boot from CD (100MB Image) Machine: Athlon Desktop (no specific name), SIS5513 Chipset Processor: Athlon 1406.077 MHz (1600+) Memory: 256MB Root Device: IDE hda: WDC WD400BB-00DEA0, ATA DISK drive hdb: WDC WD400EB-00CPF0, ATA DISK drive hdc: TEAC DV-W50D, ATAPI CD/DVD-ROM drive hdd: IOMEGA ZIP 250 ATAPI, ATAPI FLOPPY drive Root Size/partition table: hda: hda1 hda2 hda3 hda4 < hda5 hda6 hda7 hda8 hda9 > hdb: hdb1 hdb2 hdb3 hdb4 < hdb5 hdb6 hdb7 hdb8 hdb9 > Output of lspci: 00:00.0 Host bridge: Silicon Integrated Systems [SiS] 745 Host (rev 01) 00:01.0 PCI bridge: Silicon Integrated Systems [SiS] SiS 530 Virtual PCI-to-PCI bridge (AGP) 00:02.0 ISA bridge: Silicon Integrated Systems [SiS] 85C503/5513 00:02.2 USB Controller: Silicon Integrated Systems [SiS] USB 1.0 Controller (rev 07) 00:02.3 USB Controller: Silicon Integrated Systems [SiS] USB 1.0 Controller (rev 07) 00:02.5 IDE interface: Silicon Integrated Systems [SiS] 5513 [IDE] (rev d0) 00:02.7 Multimedia audio controller: Silicon Integrated Systems [SiS] Sound Controller (rev a0) 00:0b.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8029(AS) 00:0e.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10) 01:00.0 VGA compatible controller: nVidia Corporation NV17 [GeForce4 MX 440] (rev a3)
Base System Installation Checklist: Initial boot worked: [O] Configure network HW: [O] Config network: [O] Detect CD: [O] Load installer modules: [O] Detect hard drives: [O] Partition hard drives: [E] Create file systems: [ ] Mount partitions: [ ] Install base system: [ ] Install boot loader: [ ] Reboot: [ ] [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Comments/Problems: Wanted to install sarge on hdb only. hdb2 swap hdb3 /boot hdb5 / hdb6 /tmp ... No changes on hda and hdb1! Partitioning was done earlier, so I intended to assign the mount points (as described above) only. Note, that both hard disks (hda and hdb) are identically partitioned. I assigned (for instance) /tmp (with reiserfs) to hdb6 but in the resulting partition list hda6!!! was assigned to /tmp. Maybe the identical partitioning of the hard disks causes the problem. At this point I stopped installation. -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
