Package: installation-reports INSTALL REPORT
Debian-installer-version: netboot image from http://http.us.debian.org/debian/dists/testing/main/installer-sparc/current/images/ downloaded on March 23 2004. uname -a: Linux debian 2.4.24-sparc64 #1 Fri Jan 30 18:32:22 EST 2004 sparc64 GNU/Linux Date: March 23 2004, 2 PM EST. Method: Net boot. Net install from a local mirror that gets updated nightly. Machine: Sun Netra X1 Processor: UltraSPARC-IIe 500MHz Memory: 1024 MB Root Device: IDE /dev/hda1 Root Size/partition table: Disk /dev/hda (Sun disk label): 16 heads, 255 sectors, 19156 cylinders Units = cylinders of 4080 * 512 bytes Device Flag Start End Blocks Id System Mounted /dev/hda1 0 10039 20479560 1 Boot / /dev/hda2 10039 11042 2046120 82 Linux swap swap /dev/hda3 0 19156 39078240 5 Whole disk /dev/hda4 11042 19156 16552560 83 Linux native /var Disk /dev/hdc (Sun disk label): 16 heads, 255 sectors, 19156 cylinders Units = cylinders of 4080 * 512 bytes Device Flag Start End Blocks Id System Mounted /dev/hdc1 0 19156 39078240 83 Linux native /usr/local /dev/hdc3 0 19156 39078240 5 Whole disk Output of lspci: 00:00.0 Host bridge: Sun Microsystems Computer Corp. Ultra IIe 00:03.0 Non-VGA unclassified device: ALi Corporation M7101 PMU 00:05.0 Ethernet controller: Davicom Semiconductor, Inc. Ethernet 100/10 MBit (rev 31) 00:07.0 ISA bridge: ALi Corporation M1533 PCI to ISA Bridge [Aladdin IV] 00:0a.0 USB Controller: ALi Corporation USB 1.1 Controller (rev 03) 00:0c.0 Ethernet controller: Davicom Semiconductor, Inc. Ethernet 100/10 MBit (rev 31) 00:0d.0 IDE interface: ALi Corporation M5229 IDE (rev c3) Base System Installation Checklist: [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Initial boot worked: [O] Configure network HW: [O] Config network: [O] Detect CD: [ ] Load installer modules: [O] Detect hard drives: [O] Partition hard drives: [O] Create file systems: [O] Mount partitions: [O] Install base system: [O] Install boot loader: [O] Reboot: [O] Comments/Problems: The install worked but I had to ssh to the system to edit /etc/inittab by hand to comment out the tty entries and uncomment the ttyS entries because I didn't have serial console after the installer finished and the Netra X1 is a "headless" box. The only other issue is that the tulip driver detects the ethernet ports backwards from the way they are marked on the server. Net1 is eth0 and Net0 is eth1, but I think it's always been that way and it just needs to be documented someplace. -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
