Doc aka. Uwe A. P. Wuerdinger wrote: > when I try to load the ne.o network drive in default installation mode I > don't have a chance to append the IO Address. > Workaround: Lower the debconf priority or use expert mode.
I think perhaps hw-detect should, if the prompt was not initially displayed, and a module fails to load, prompt again for parameters at a higher priority and try the module load again. Does this make sense? > installation of ne.o still fails. > Workaround: switch to shell > #modprobe crc32 > #modprobe 8390 > #modprobe isa-pnp ne.o depends on these and depmod finds the dependnencies so I don't understand why a manual load would be needed. If I modprobe ne in d-i, it loads the above three modules first (of course ne itself fails to load as I have no such card). -- see shy jo
signature.asc
Description: Digital signature
