#include <hallo.h> Neil S Hamilton wrote on Sun Jul 14, 2002 um 09:41:11PM:
> /etc/lilo.conf (I can't currently copy/paste this) installs the MBR to > /dev/sda and gives the root as /dev/sda3. > > Running Lilo seems to go fine, but on reboot, with SCSI selected in the > BIOS, I get a string of numbers printed when LILO loads - I _think_ this > is the letter "L", followed by "01 01 01 01 01...." which I understand IDE/SCSI mixture is your problem. You should already know it if you use a such combination, if you don't - RTFM. The installer suggests to create a boot floppy - did you? > Please - can anybody help me with this configuration. All I want to > achieve is a basic install to work on, of the 2.4.18 kernel, supporting > my Adaptec 2100s and my 3Com 3c905 network cards (I understand the > 3c59x.o module does that). Run setup again. Do the same things. After you installed LILO the first time, go to the second console. Run "chroot /target". Run "editor /etc/lilo.conf". READ THE COMMENTS. There is an example for you. Modify as needed. Then exit nano and run lilo. Hm, I think you will also need to "mount /proc" before and "umount /proc" afterwards. > Any help would be greatly appreciated, as I'm going round in circles and > running out of ideas. Uhm. Without ideas, you should on the internet. Gruss/Regards, Eduard. -- We just typed make... (Stephen Lambrigh, Director of Server Product Marketing at Informix about porting their Database to Linux) -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
