Package: installation-reports Boot method: iso mounted into virtual machine Image version: http://cdimage.debian.org/cdimage/wheezy_di_rc1/amd64/iso-cd/debian-wheezy-DI-rc1-amd64-netinst.iso Date: 2013-04-02 12:50:00 CEST
Machine: VMware ESX 5.1 Virtual Machine, configured to run Debian 6.0 AMD 64 Processor: Intel Xeon E5-26500 (1vCPU) Memory: 1024MB Partitions: none specified Output of lspci -knn (or lspci -nn): Base System Installation Checklist: [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Initial boot: [O] Detect network card: [O] Configure network: [E] Detect CD: [ ] Load installer modules: [ ] Detect hard drives: [ ] Partition hard drives: [ ] Install base system: [ ] Clock/timezone setup: [ ] User/password setup: [ ] Install tasks: [ ] Install boot loader: [ ] Overall install: [ ] Comments/Problems: On my network we have IPv6 enabled. I wanted to configure the new box IPv6 only with a fixed Address to test. Booting off the RC1 ISO, I set following options Regular install Language: English Country: Austria Default Setting: en_US.UTF-8 Keymap: German At the nameserver screen I go back twice to specify a fixed IPv6 Address. IP Address: 2001:629:1005:323::161 Netmask: ffff:ffff:ffff:ffff:: Gateway: 2001:629:1005:323::1 Nameservers: 2001:629:1001:1::53 2001:629:1001:2::53 Then the screen stays blue and never goes on. On console 4 I see the following logmessage looping: nc_v6_interface_configured(eth0, scope global) Running ip addr show eth0 to look for address ip line: 2: eth0:<BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qd isc pfifo_fast qlen 1000 ip line: link/ether 00:50:56:be:XX:XX brd ff:ff:ff:ff:ff:ff ip line: inet6 2001:629:1005:323:250:56ff:febe:XXXX/64 scope global dynamic ip line: valid_lft 2591972sec preffered_lft 604772sec ip line: inet6 2001:629:1005:323::161/64 scope global tentative flags 08 ip line: valid_lft forever preffered_lft forever ip line: inet6 fe80::250:56ff:febe:XXXX/64 scope link ip line: valid_lft forever preffered_lft forever On console 2 I can ping both nameservers but the installer hangs at a blue screen. Thanks Philipp -- To UNSUBSCRIBE, email to debian-boot-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org Archive: http://lists.debian.org/515ac203.3060...@kolmann.at