Package: installation-reports
Boot method: CD Net Installer
Image version: 6.0 (squeeze) - installer build 20110101-03:54
Date: a) 4-Jan-2011
b) 4-Jan-2001
Machine: a) Laptop Packard-Bell
b) Laptop OEM
Processor: a) 800 MHz Celeron, 128 Kb cache
b) 2.8 GHz Celeron, 256 Kb cache
Memory: a) 384 Kb
b) 448 Kb
Partitions: a)
Filesystem 1K-blocks Used Available Use% Mounted on
tmpfs 188560 52 188508 0% /dev
/dev/sda1 964500 141336 774168 15% /target
/dev/sda5 1921156 192752 1630812 11% /target/home
/dev/sda8 1004024 18364 934656 2% /target/opt
/dev/sda6 2885780 1780004 959188 65% /target/usr
/dev/sda7 1921156 170400 1653164 9% /target/var
/dev/sda1 964500 141336 774168 15% /dev/.static/dev
tmpfs 188560 52 188508 0% /target/dev
b)
Filesystem 1K-blocks Used Available Use% Mounted on
tmpfs 225136 60 225076 0% /dev
/dev/sda5 964500 143604 771900 16% /target
/dev/sda6 1921156 1182596 640968 65% /target/home
/dev/sda9 7732320 148472 7191064 2% /target/opt
/dev/sda7 4806904 2620652 1942068 57% /target/usr
/dev/sda8 2885780 224016 2515176 8% /target/var
/dev/sda5 964500 143604 771900 16% /dev/.static/dev
tmpfs 225136 60 225076 0% /target/dev
Wireless Interface:
a)
Jan 4 00:19:08 kernel: [ 106.649409] cfg80211: Calling CRDA for
country: US
Jan 4 00:19:08 kernel: [ 106.772976] p54pci 0000:02:00.0: PCI INT
A -> Link[LNKA] -> GSI 9 (level, low) -> IRQ 9
Jan 4 00:19:08 kernel: [ 106.773115] p54pci 0000:02:00.0:
firmware: requesting isl3886pci
Jan 4 00:19:08 kernel: [ 106.797935] phy0: p54 detected a LM86
firmware
Jan 4 00:19:08 kernel: [ 106.797949] p54: rx_mtu reduced from 3240
to 2376
Jan 4 00:19:08 kernel: [ 106.797956] phy0: FW rev 2.13.1.0 -
Softmac protocol 5.5
Jan 4 00:19:08 kernel: [ 106.797964] phy0: cryptographic
accelerator WEP:YES, TKIP:YES, CCMP:YES
Jan 4 00:19:09 kernel: [ 107.707178] phy0: hwaddr
00:09:5b:ee:e5:0e, MAC:isl3886 RF:Frisbee
Jan 4 00:19:09 kernel: [ 107.744275] phy0: Selected rate control
algorithm 'minstrel'
Jan 4 00:19:09 kernel: [ 107.746572] Registered led device:
p54-phy0::assoc
Jan 4 00:19:09 kernel: [ 107.746638] Registered led device:
p54-phy0::tx
Jan 4 00:19:09 kernel: [ 107.746694] Registered led device:
p54-phy0::rx
Jan 4 00:19:09 kernel: [ 107.746749] Registered led device:
p54-phy0::radio
Jan 4 00:19:09 kernel: [ 107.746770] p54pci 0000:02:00.0: is
registered as 'phy0'
Jan 4 00:19:09 net/hw-detect.hotplug: Detected hotpluggable network
interface wlan0
Jan 4 00:19:10 check-missing-firmware: no missing firmware in
/dev/.udev/firmware-missing
b)
Jan 4 18:49:23 kernel: [ 55.562608] cfg80211: Calling CRDA for
country: US
Jan 4 18:49:23 net/hw-detect.hotplug: Detected hotpluggable network
interface eth0
Jan 4 18:49:23 kernel: [ 55.740026] usb 1-4: reset high speed USB
device using ehci_hcd and address 2
Jan 4 18:49:23 kernel: [ 55.884328] phy0: Selected rate control
algorithm 'minstrel'
Jan 4 18:49:23 kernel: [ 55.885288] zd1211rw 1-4:1.0: phy0
Jan 4 18:49:23 kernel: [ 55.885326] usbcore: registered new
interface driver zd1211rw
Jan 4 18:53:05 kernel: [ 277.906060] usb 1-4: firmware: requesting
zd1211/zd1211b_ub
Jan 4 18:53:05 kernel: [ 277.911132] usb 1-4: firmware: requesting
zd1211/zd1211b_uphr
Jan 4 18:53:05 kernel: [ 277.958073] zd1211rw 1-4:1.0: firmware
version 4725
Jan 4 18:53:05 kernel: [ 277.998073] zd1211rw 1-4:1.0: zd1211b
chip 050d:705c v4810 high 00-11-50 AL2230_RF pa0 g--N-
Jan 4 18:53:05 kernel: [ 278.000462] cfg80211: Calling CRDA for
country: US
Jan 4 18:53:05 kernel: [ 278.019523] ADDRCONF(NETDEV_UP): wlan0:
link is not ready
Jan 4 18:53:06 check-missing-firmware: no missing firmware in
/dev/.udev/firmware-missing
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot: [O]
Detect network card: [O]
Configure network: [O]
Detect CD: [O]
Load installer modules: [O]
Detect hard drives: [O]
Partition hard drives: [O]
Install base system: [O]
Clock/timezone setup: [O]
User/password setup: [O]
Install tasks: [O]
Install boot loader: [O]
Overall install: [O]
Comments/Problems:
Much better !
Squeeze beta 2 would not install - Configure network failed with:
wlan0: deauthenticating from 00:0f:b5:1b:2c:84 by local choice
(reason=3)
With 1-Jan-11 overnight build: authentication is successful;
link stays up as long as it is busy but goes down if idle long enough,
like while software is being installed
running Detect network card / Configure network again brings WLAN
back up
so grub can be downloaded and installed.
<Description of the install, in prose, and any thoughts, comments
and ideas you had during the initial install.>
a) LXDE desktop - no network manager, start wpa etc by hand OK.
Install network-manager and network-manager-gnome.
Reboot ... with p54pci device no WLAN:
wlan0: deauthenticating from 00:0f:b5:1b:2c:84 by local choice
(reason=3)
Reboot with zd1211rw instead ... recognised as wlan1 ... WLAN
connection OK.
After
sudo /etc/init.d/network-manager stop
sudo killall wpa
able to start WLAN by hand, both wlan0 and wlan1.
b) KDE desktop - network manager already installed ... no WLAN ...
wlan0: deauthenticating from 00:0f:b5:1b:2c:84 by local choice
(reason=3)
But after
sudo /etc/init.d/network-manager stop
sudo killall wpa
able to start WLAN by hand.
Command used to start WLAN by hand:
wpa_supplicant -B -c/etc/wpa-psk-tkip.conf -iwlan0
Contents of /etc/wpa-psk-tkip.conf
ctrl_interface=/var/run/wpa_supplicant
network={
ssid="Custards"
key_mgmt=WPA-PSK
proto=WPA
pairwise=TKIP
group=TKIP
psk=****************************************************************
}
Network manager worked with lenny and has worked with earlier squeeze
update / installation trials. What is wrong now ?
Is this a network manager issue ?
If so, where should I report it ?
What information should I provide ?
--
To UNSUBSCRIBE, email to debian-boot-requ...@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org
Archive: http://lists.debian.org/4d25089d.5000...@yahoo.co.uk
