hi all:
I use squeeze Nov 6 build iso to install, i had three network
interface card, a onboard NIC and two stand alone NIC is intel e1000,
and e1000 1st(eth1) is plug a cable, e1000 2nd(eth2) and
onboard(eth0) is not, i want to auto configure the NIC which plug cable (at
this is e1000 1st, eth1),
so i write interface=auto as boot parameter, but when get ip from dhcp
server, the installation can't get ip. when i configure network manually,
found the ip configure onboard NIC, that is say the ip is configure on
eth0 not eth1. any idea? Or may be is a bug? If i want to auto configure the
NIC which plug cable, how to?
best regards
Qin Bo
